Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio MP7001 — Trang 20/28

Code: 783-5

Description: Crease Motor Error Multi Folder (D454)
The motor drive PCB detected an error at the motor.
Causes: • Motor harness or connector loose, broken, defective • Motor or motor drive board defective
Remedy:

Code: 783-6

Description: Dynamic Roller Transport Motor Error Multi Folder (D454)
The motor drive PCB detected an error at the motor.
Causes: • Motor harness or connector loose, broken, defective • Motor or motor drive board defective
Remedy:

Code: 783-7

Description: Reg. Roller Transport Motor Error Multi Folder (D454)
The motor drive PCB detected an error at the motor.
Causes: • Motor harness or connector loose, broken, defective • Motor or motor drive board defective
Remedy:

Code: 783-8

Description: Dynamic Roller Lift Motor Error Multi Folder (D454)
The dynamic roller HP sensor did not detect the dynamic roller in (or out of) its home position within the prescribed time. The 1st occurrence causes a jam, and the 2nd occurrence causes this SC code.
Causes: • Dynamic roller HP sensor dirty • Sensor harness or connector loose, broken, defective • Dynamic roller lift motor harness or connector loose, broken, defective • Sensor defective • Motor or motor drive board defective
Remedy:

Code: 783-9

Description: Registration Roller Release Motor Error Multi Folder (D454)
The registration roller HP sensor did not detect the registration roller in (or out of) its home position within the prescribed time. The 1st occurrence causes a jam, and the 2nd occurrence causes this SC code.
Causes: • Registration roller HP sensor dirty • Sensor harness or connector loose, broken, defective • Registration roller release motor harness or connector loose, broken, defective • Sensor defective • Motor or motor drive board defective
Remedy:

Code: 784

Description: Z-fold timing unit fold timing sensor adjustment error
The A/D (Digital/ Analog) input value did not change even after
the D/A (Digital/ Analog) output value changed.
Causes: • Fold timing sensor connector loose, broken, defective • Fold timing sensor defective • Fold timing sensor, mylar covered with paper dust • Mylar disconnected.
Remedy:

Code: 785

Description: Z-fold leading edge sensor adjustment error
The A/D input value did not change even after the D/A output value changed.
Causes: • Leading edge sensor connector loose, broken, defective • Leading edge sensor defective • Leading edge sensor, mylar covered with paper dust • Mylar disconnected.
Remedy:

Code: 786

Description: Z-fold EEPROM error
The write operation to the Z-folding EEPROM failed after 2 attempts
Causes: • EEPROM defective
Remedy:
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie