Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio MP7001 — Trang 23/28

Code: 854

Description: Wireless LAN Error 2
The board that holds the wireless LAN card can be accessed, but the wireless LAN card (802.11b/Bluetooth) itself could not be accessed while the machine was operating.
Causes: • Wireless LAN card has been removed.
Remedy:

Code: 855

Description: Wireless LAN Error 3
An error is detected for the wireless LAN card (802.11b or Bluetooth).
Causes: • Wireless LAN card defective • Wireless card connection not tight
Remedy:

Code: 856

Description: Wireless LAN Error 4
An error is detected for the wireless LAN board (802.11b or Bluetooth).
Causes: • Wireless LAN card board defective. • PCI connector loose (External controller interface board).
Remedy:

Code: 857

Description: USB I/F Error 1
The USB driver is unstable and generated an error. The USB I/F cannot be used.
Causes: • USB board or controller board defective
Remedy:

Code: 858

Description: Data Encryption Error 1
These are errors of the HDD Data Encryption Option D377.
Causes: 0 Key Acquistion Key could be acquired. • Replace the controller board 1 HDD Key Setting Error The key was acquired but the HDD could not be set. • Turn the machine power off/on several times. • Replace the controller board. 2 NVRAM Read Error NVRAM data conversion failed (mismatch with nvram.conf) • Replace the NVRAM 30 NVRAM Before Replace Error DFU. May occur during development. • Turn the machine power off/on several times. • Replace the controller board. 31 Other Error An unexpected error occurred while data was being converted. This error is the same as SC991. See SC991 below.
Remedy:

Code: 859

Description: Data Encryption Error 2
These are errors of the HDD Data Encryption Option D377.
Causes: 8 HDD Check Error Data conversion was attempted with no HDD unit present. • Confirm that HDD unit installed correctly • Initialize HDD with SP5832-1 Note: After installation, a new HDD should be formatted with SP5832-1 9 Power Loss During Data Conversion Data conversion stopped before NVRAM/HDD data was converted. • Format HDD with SP5832-1 10 Data Read Command Error More than two illegal DMAC communications were returned. • HDD defective • Format HDD with SP5832-1 • Replace HDD
Remedy:

Code: 860

Description: HDD startup error at power on
HDD is connected but a driver error is detected. The driver does not respond with the status of the HDD within 30 s.
Causes: • HDD is not initialized • Level data is corrupted • HDD is defective
Remedy:

Code: 861

Description: HDD Error 2: HDD Startup
The hard disks were detected at power on, but the disks were not detected within 30s after recovery from the energy conservation mode.
Causes: • Cable between the hard disks and controller board disconnected or loose • Hard disk power connector loose • One of the hard disks is defective • Controller defective
Remedy:
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie