Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio MP7001 — Trang 22/28

Code: 823

Description: Self-diagnostic error: NIB
Causes: [6101] MAC address check sum error The result of the MAC address check sum does not match the check sum stored in ROM. [6104] PHY IC error The PHY IC on the controller cannot be correctly recognized. [6105] PHY IC loop-back error An error occurred during the loop-back test for the PHY IC on the controller. - 1. Replace the controller.
Remedy:

Code: 824

Description: Self-diagnostic error 4: NVRAM
One or more of the following conditions exist: • NVRAM not present. • NVRAM damaged • NVRAM socket damaged
Causes: • NVRAM defective • Controller board defective • NVRAM backup battery exhausted • NVRAM socket damaged Note: In every case, the controller board must be replaced.
Remedy:

Code: 829

Description: Self-diagnostic Error: Optional RAM
The optional RAM returned an error during the self-diagnostic test.
Causes: • Replace the optional memory board • Controller board defective
Remedy:

Code: 833

Description: Self-diagnostic error 8: Engine I/F ASIC
Causes: 0F30 0F31 ASIC (Mandolin) for system control could not be detected. After the PCI configuration, the device ID for the ASIC could not be checked. • ASCI (Mandolin) for system control is defective • Interface between North Bridge and AGPI is defective • Replace the mother board 0F41 The read/write check done for resident RAM on the mother board could not be done correctly. • Memory device defective • Replace the mother board 50B1 Could not initialize or read the bus connection. • Bus connection defective, loose • SSCG defective • Replace the mother board 50B2 Value of the SSCG register is incorrect. • Bus connection loose, defective • SSCG defective • Replace the mother board
Remedy:

Code: 834

Description: Self-diagnostic error 9: Optional Memory RAM DIMM
Causes: 5101 The write/verify check for the optional RAM chip on the engine mother board gave an error. • Controller defective • Mother board defective
Remedy:

Code: 838

Description: Self-diagnostic Error: Clock Generator
A verify error occurred when setting data was read from the clock generator via the I2C bus.
Causes: • Replace the controller board
Remedy:

Code: 851

Description: IEEE 1394 I/F error
Driver setting incorrect and cannot be used by the 1394 I/F.
Causes: • NIB (PHY), LINK module defective; change the Interface Board • Controller board defective
Remedy:

Code: 853

Description: Wireless LAN Error 1
During machine start-up, the machine can get access to the board that holds the wireless LAN, but not to the wireless LAN card (802.11b or Bluetooth).
Causes: • Wireless LAN card missing (was removed)
Remedy:
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie