Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio MP9002

Code: 101

Description: Exposure Lamp Error At trigger on, the lamp was not detected on.
Causes: • SBU board defective • SIOB board defective • IPU board defective • BCU board defective • Exposure lamp defective • Lamp stabilizer defective • Lamp stabilizer harness damaged, disconnected • Standard white plate dirty, disconnected or has condensation • DF white belt dirty • DF glass dirty or has condensation • Scanner mirror dirty, out of position or has condensation • Lens dirty, out of position

Code: 120

Description: Scanner home position error 1 The scanner HP sensor does not detect the OFF condition during initialization or copying.
Causes: • BCU, SIOB defective • Scanner motor defective • Scanner HP sensor defective. • Harness between BCU, SIOB, scanner motor disconnected. • Harness between scanner HP sensor and BCU disconnected. • Scanner wire, timing belt, pulley, or carriage installed incorrectly.

Code: 121

Description: Scanner home position error 2 The scanner HP sensor does not detect the ON condition during initialization or copying.
Causes: • BCU, SIOB defective • Scanner motor defective • Scanner HP sensor defective • Harness between BCU, SIOB, scanner motor disconnected • Harness between scanner HP sensor and BCU disconnected • Scanner wire, timing belt, pulley or carriage installed incorrectly.

Code: 141

Description: Black level detection error The black level cannot be adjusted within the target during auto gain control.
Causes: • Harness between SBU – SIOB is disconnected. • Harness between SIOB – BCU is disconnected. • Defective SBU • Defective BCU

Code: 142

Description: White level detection error The white level cannot be adjusted to the second target level within the target during auto gain control.
Causes: • Dirty exposure lamp or optics section • SBU board defective • SIOB defective • IPU board defective • BCU board defective • Harnesses are disconnected. • Exposure lamp defective • Lamp stabilizer defective • Scanner motor defective

Code: 144

Description: SBU transmission error After the SBU switches on, the BCU detects one of the following conditions on the SBU: • 1 s after power on, the SYDO signal does not go high, even after 1 retry. • 1 s after power on, the SYDO signal goes high, but the SBU ID could not be read after 3 attempts.
Causes: • SBU defective • SIOB defective • BCU defective • Harness between the SBU - SIOB is disconnected • Harness between the SIOB - BCU is disconnected • Harness between the SIOB – PSU is disconnected

Code: 161-01

Description: IPU error The error result of self-diagnostic by the ASIC on the BICU is detected.
Causes: • Defective BICU • Defective connection between BICU and SBU

Code: 161-02

Description: IPU error (LSYNC abnormal) The error result of self-diagnostic by the ASIC on the BICU is detected.
Causes: • Defective BICU • Defective connection between BICU and SBU
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie