Causes: The fan motor lock (rotating state) signal is sampled at 100 ms intervals and the machine fails to receive the lock signal 50 times in succession. • Failed fan motor • Disconnected connector
Remedy: • Replace the fan motor. • Check the connector. • Replace the harness. • Replace the IOB.
Causes: The fan motor lock (rotating state) signal is sampled at 100 ms intervals and the machine fails to receive the lock signal 50 times in succession. • Failed fan motor • Disconnected connector • Harness disconnection • Defective IOB
Remedy: • Replace the fan motor. • Check the connector. • Replace the harness. • Replace the IOB.
Causes: The fan motor lock (rotating state) signal is sampled at 100 ms intervals and the machine fails to receive the lock signal 50 times in succession. • Failed fan motor • Disconnected connector • Harness disconnection • Defective IOB
Remedy: • Replace the fan motor. • Check the connector. • Replace the harness. • Replace the IOB.
Causes: The condition whereby the temperature is -20 deg C or less for 5 seconds has been detected 10 times or more. • Broken thermistor wire • Bad connector contact
Remedy: • Clear the SP: fusing SC. • Check the connector connection. • Replace the fusing (Center) thermistor.
Description: Fusing lamp (Center) thermistor not reloaded 1
Causes: The heater thermistor has increased by less than 2.0 degrees in 1.5 seconds 5 times in a row. • Deformed or floating thermistor • Input voltage out of range
Remedy: • Clear the SP: fusing SC. • Replace the thermistor.
Description: Fusing lamp (Center) thermistor not reloaded 2
Causes: The heater (Center) thermistor does not reach the reload temperature 50 seconds after the start of motor rotation. • Fusing lamp disconnected • The overtemperature prevention mechanism started working
Remedy: • Clear the SP: fusing SC. • Replace the thermistor.
Causes: The hardware high-temperature error sensor flag is detected. • Damaged triac (shorted) • Failed engine control board • Failed fusing thermopile • Failed fusing thermistor • Abnormal fusing control software behavior • The PWM signal is continuously supplied from the IH inverter (due to a software or temperature sensor error).
Remedy: • Clear the SP: fusing SC. • Replace the PSU. • Replace the Engine Board. • Replace the fusing thermopile. • Replace the Fusing Unit.
Nhận ưu đãi sớm nhất khi chương trình diễn ra
Đăng ký nhận bản tin
Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này.
Chính sách cookie
Những cookie này là cần thiết để trang web hoạt động đúng cách.
Những cookie này giúp chúng tôi hiểu cách khách truy cập tương tác với trang web.
Những cookie này được sử dụng để cung cấp quảng cáo cá nhân hóa.