• Code: SC101-00
• Description: Exposure Lamp Error
• Causes: The scanner has scanned the white plate, but cannot detect the certain white level. • Defective exposure lamp • Defective exposure lamp stabilizer • Defective power source harness • Defective signal harness • High-voltage cable leak • Defective darkness starting characteristic
• Remedy: Turn the main power OFF and then ON.

• Code: SC101-01
• Description: Exposure Lamp Error
• Causes: The scanner has scanned the white plate, but cannot detect the certain white level. • Defective exposure lamp • Defective exposure lamp stabilizer • Defective power source harness • Defective signal harness • High-voltage cable leak • Defective darkness starting characteristic
• Remedy: Turn the main power OFF and then ON.

• Code: SC120
• Description: Scanner home position error 1
• Causes: The scanner home position sensor does not detect the scanner leaving the home position. • Defective scanner home position sensor • Defective scanner home position sensor harness • Defective scanner motor driver • Defective scanner motor
• Remedy: Turn the main power OFF and then ON.

• Code: SC121
• Description: Scanner home position error 2
• Causes: The scanner home position sensor does not detect the scanner coming back to the home position. • Defective scanner home position sensor • Defective scanner home position sensor harness • Defective scanner motor driver • Defective scanner motor
• Remedy: Turn the main power OFF and then ON.

• Code: SC230-00
• Description: FGATE*1 : Does not turn ON. (*1)FGATE: Signals used between the controller and the engine in order to send the information about the sub scan length of the page to be printed.
• Causes: GPIO*2 has not been asserted, although the specified time (200 ms) elapsed after setting JOB to be started and reaching the FGAT assert time. • Engine board defective • ASIC defective • Controller board defective • Harness disconnection (*2)GPIO: A type of input/output terminal
• Remedy: Turn the main power OFF and then ON.

• Code: SC231-00
• Description: FGATE*1: Does not turn OFF. (*1)FGATE: Signals used between the controller and the engine in order to send the information about the sub scan length of the page to be printed.
• Causes: GPIO*2 has not been negated, although the specified time (200 ms) elapsed after detecting GPIO*assert and then reaching the expected FGATE negate time. • Engine board defective • Write ASIC defective • Controller board defective • Harness disconnection (*2)GPIO: A type of input/output terminal
• Remedy: Turn the main power OFF and then ON.

• Code: SC270-00
• Description: Write ASIC communication error
• Causes: The unique ID of the write ASIC was not read normally. • Engine board defective • Write ASIC defective
• Remedy: • Turn the main power OFF and then ON. • Engine Board

• Code: SC277-00
• Description: LEDA communication error
• Causes: The head type data was read three times in succession (277-00) • Defective ASIC • Defective LEDA (277-10) • LEDA power source error
• Remedy: • Turn the main power OFF and then ON. • Replace the LED head