Description: HDD startup error at power on CTL HDD is connected but a driver error is detected. The driver did not respond with the status of the HDD within 30 sec.
Causes: •X HDD is not initialized •X Level data is corrupted •X Initialize the HDD with SP5-832-001. •X HDD is defective
Description: HDD Error 2: HDD Startup CTL The hard disks were detected at power on, but the disks were not detected within 30s after recovery from the energy conservation mode.
Causes: •X Cable between the hard disks and controller board disconnected or loose •X Hard disk power connector loose •X One of the hard disks is defective •X Controller defective
Description: HDD data read failure CTL The data written to the HDD cannot be read normally, due to bad sectors generated during operation.
Causes: •X HDD defective •X Controller defective. Note: If the bad sectors are generated at the image partition, the bad sector information is written to NVRAM, and the next time the HDD is accessed, these bad sectors will not be accessed for read/write operation.
Description: HDD data CRC error CTL During HDD operation, the HDD cannot respond to a CRC error query. Data transfer did not execute normally while data was being written to the HDD.