Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh D159 MP2001L K-C4 — Trang 4/13

Code: 322

Description: Laser synchronization error
The main scan synchronization detector board cannot detect the laser synchronization signal for more than 5 consecutive 100 ms intervals.
Causes: • Poor connection between the laser unit and the BICU board • Damaged cable between BICU and laser unit • Laser unit • BICU board

Code: 350

Description: ID sensor error (In-process)
Vsg adjustment error Vsp error Vsg error Vsg-Vsp error TD sensor error
Causes: • Dirt on the ID sensor • ID sensor not installed at the correct angle. • Defective ID sensor • Defective PCU • Development roller is not rotating

Code: 351

Description: ID sensor : Vsg measurement error (In-process) (D158/D159)
When the ID sensor detects that Vsg is 5 V and LED drive current is minimum (PWM=0).
Causes: • Defective ID sensor • Disconnection of the harness to the ID sensor • Bad electrical contact of the ID sensor connector • Defective BCU • Defective laser unit • Defective developer density • Defective high-voltage power pack • Dirty ID sensor

Code: 353

Description: ID sensor : Auto adjustment value error (In-process) (D158/D159)
When the ID sensor is adjusting Vsg automatically.
Causes: • Defective ID sensor • Disconnection of the harness to the ID sensor • Bad electrical contact of the ID sensor connector • Defective BCU • Defective laser unit • Defective developer density • Defective high-voltage power pack • Dirty ID sensor

Code: 354

Description: ID sensor : Auto adjustment time-out (In-process) (D158/D159)
When the ID sensor is adjusting Vsg automatically.
Causes: • Defective ID sensor • Disconnection of the harness to the ID sensor • Bad electrical contact of the ID sensor connector • Defective BCU • Defective laser unit • Defective developer density • Defective high-voltage power pack • Dirty ID sensor

Code: 355

Description: P sensor error (D158/D159)
SC350-354 happen during normal operation. This error isn't displayed on the panel but is left in the error log.
Causes: • Defective ID sensor • Disconnection of the harness to the ID sensor • Bad electrical contact of the ID sensor connector • Defective BCU • Defective laser unit • Defective developer density • Defective high-voltage power pack • Dirty ID sensor

Code: 389

Description: TD sensor error (D158/D159)
Detected the following value TD sensor output value < 0.2V TD sensor output value > 4.0V 10 times in series.
Causes: • Defective TD sensor • Bad contact of the connector to the TD sensor

Code: 390

Description: TD sensor error
The TD sensor outputs less than 0.2 V or more than 4.0 V 10 times consecutively during copying.
Causes: • TD sensor abnormal • Poor connection of the PCU
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie