Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh D159 MP2001L K-C4 — Trang 5/13

Code: 391

Description: Development bias leak
A development bias leak signal is detected.
Causes: • Poor connection of the PCU • High voltage supply board

Code: 392

Description: TD sensor initial setting error
TD sensor initial setting is not performed correctly.
Causes: • ID sensor • No developer • Drum does not turn • Development roller does not turn • Poor connection of the PCU • The voltage is not applied to charge roller

Code: 440

Description: Image transfer positive electrode current error
An interrupt checks the status of the power pack every 20 ms. This SC is issued if the BCU detects a short in the power pack 10 times consecutively.
Causes: • Defective image transfer roller • Defective high voltage supply unit • Connection error • Image transfer unit is not installed correctly.

Code: 460

Description: Separation power pack output error (D158/D159)
An interrupt checks the status of the power pack every 20 ms. This SC is issued if the BCU detects a short in the power pack 10 times at D (ac).
Causes: • High-voltage leak • Loose connection • Broken harness • Defective-high voltage supply unitt

Code: 490

Description: Toner transport motor error (D158/D159)
When the toner transport motor is ON
Causes: • Motor lock • Defective motor drive

Code: 501

Description: Tray 1 lift motor malfunction (Optional paper tray units)
The paper lift sensor fails to activate twice continuously after the tray lift motor has been on for 12 seconds
Causes: • Paper lift sensor • Tray lift motor • Too much load on the drive mechanism • Poor tray lift motor connections

Code: 502

Description: Tray 2 lift motor malfunction (Optional paper tray units)
The paper lift sensor fails to activate twice continuously after the tray lift motor has been on for 12 seconds
Causes: • Paper lift sensor • Tray lift motor • Too much load on the drive mechanism • Poor tray lift motor connections.

Code: 503

Description: Tray 3 error (D160/D161/D170)
The paper lift sensor fails to activate three times continuously after the tray lift motor has been on for 18 seconds.
Causes: • Paper lift sensor • Tray lift motor • Broken harness • Defective bank controller board
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie