Description: Fusing temperature warm-up error (rear) (D158/D159) The fusing temperature rises less than 4 degrees in 2 seconds, and this continues 5 times consecutively.
Causes: • Fusing thermistor defective or out of position • Power supply board
Description: Fusing temperature warm-up error (rear) (D158/D159) The fusing temperature does not reach the target with in 28 seconds after the fusing lamp controller is activated.
Description: Fusing lamp overheat error (rear) After the fusing temperature reaches the target temperature, the fusing lamp does not turn off for 20 consecutive seconds.
Causes: Fusing thermistor defective or out of position • Power supply board
Description: Zero cross frequency error (D158/D159) The detection error occurs 10 times or more in 11 frequency detections. This error is defined when the detected zero cross signal is more than 66.
Description: Jam error detected 3 times in succession The exit sensor and the duplex sensor detect a paper jam 3 times in succession This condition can occur when SP1-159-001 is set to ‘on’. The default is ‘off’.
Causes: • Paper jams can occur for the following reasons. • Dampness • Paper curl • Incorrect paper setting in the paper tray • Stripper pawls coming apart
Nhận ưu đãi sớm nhất khi chương trình diễn ra
Đăng ký nhận bản tin
Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này.
Chính sách cookie
Những cookie này là cần thiết để trang web hoạt động đúng cách.
Những cookie này giúp chúng tôi hiểu cách khách truy cập tương tác với trang web.
Những cookie này được sử dụng để cung cấp quảng cáo cá nhân hóa.