• Code: 877
• Description: HDD Data Erase Error The Data Overwrite Security option cannot scramble and erase data on the HDD because the DOS SD card has been corrupted or has
• Causes: • If the DOS SD card has been removed, switch the machine off, install the SD card, then switch on the machine. (If this does not been removed from the SD card slot.
• Remedy: • If the DOS SD card has been removed, switch the machine off, install the SD card, then switch on the machine. (If this does not solve the problem, the SD card has been damaged.) • Install a new NVRAM • Install a new Data Overwrite Security option with a new SD card

• Code: 880
• Description: File Format Converter (MLB) error A request to access the MLB was not answered within the specified time (60 sec.).
• Causes: • File format converter board defective
• Remedy:

• Code: 900
• Description: Electrical total counter error The total counter contains something that is not a number.
• Causes: • NVRAM incorrect type • NVRAM defective • NVRAM data scrambled • Unexpected error from external source
• Remedy:

• Code: 901
• Description: Mechanical Total Counter The mechanical counter is not connected.
• Causes: • Mechanical counter connection loose, broken, defective • Replace the mechanical counter
• Remedy:

• Code: 910 ... 914
• Description: 910 B External controller error 1 911 B External controller error 2 912 B External controller error 3 913 B External controller error 4 914 B External controller error 5 The external controller alerted the machine about an error.
• Causes: • Refer to the instructions for the external controller
• Remedy:

• Code: 919
• Description: External controller error 6 While EAC (External Application Converter), the conversion module, was operating normally, the receipt of a power line interrupt signal from the FLUTE serial driver was detected, or BREAK signal from the other station was detected.
• Causes: • Controller RW3600 power outtage • Controller RW3600 rebooted • Connection to Controller RW3600 loose
• Remedy:

• Code: 920
• Description: Printer error 1 An internal application error was detected and operation cannot continue.
• Causes: • Software defective • Turn the machine power off/on, or change the controller firmware • Insufficient memory
• Remedy:

• Code: 921
• Description: Printer Error 2 When the printer application started, the font designated for use could not be found on the SD card.
• Causes: • The font is not on the SD card
• Remedy: