Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh M075 SPC320DN MD-P2 — Trang 6/9

Code: 856

Description: Wireless LAN error 4
An error is detected on the wireless LAN board.
Causes: • Wireless LAN board defective • PCI connector to EGB loose
Remedy:

Code: 857

Description: USB I/F Error
The USB driver is not stable and caused an error.
Causes: • Poor USB card connection • Replace the controller board
Remedy:

Code: 858

Description: Data Encryption Error 1
These are errors of the HDD Data Encryption Option.
Causes: 0 Key Acquisition Key can be acquired. • Replace the controller board. 1 HDD Key Setting Error The key is acquired but the HDD can not be set. • Turn the machine power off/on several times. • Replace the controller board. 2 NVRAM Read Error NVRAM data conversion fails (mismatch with nvram.conf). • Replace the NVRAM. 30 NVRAM Before Replace Error An error which may be recovered after recycling the power occurs before replacing NVRAM. Turn the machine power off/on several times. Replace the controller board. 31 Other Error An unexpected error occurs while data is being converted. This error is the same as SC991. See SC991 below.
Remedy:

Code: 859

Description: Data Encryption Error 2
These are errors of the HDD Data Encryption Option.
Causes: 8 HDD Check Error Data conversion is attempted with no HDD unit present. • Confirm that HDD unit installed correctly. • Initialize HDD with SP5832-1. Note: After installation, a new HDD should be formatted with SP5832-1. 9 Power Loss During Data Conversion Data conversion stops before NVRAM/HDD data is converted. • Format HDD with SP5832-1. 10 Data Read Command Error More than two illegal DMAC communications are returned. • HDD defective • Format HDD with SP5832-1. • Replace HDD.
Remedy:

Code: 860

Description: HDD startup error at power on
HDD is connected but a driver error is detected. -or- The driver does not respond with the status of the HDD within 30 s.
Causes: • HDD is not initialized. • Level data corrupted • HDD is defective.
Remedy:

Code: 861

Description: HDD re-try failure
At power on the HDD is detected. Power supply to the HDD is interrupted after the system has entered the energy save mode, but after the HDD has been awakened from the energy save mode it does not return to the ready status within 30 sec.
Causes: • Harness between HDD and controller board disconnected, defective • HDD power connector disconnected • HDD defective • Controller board defective
Remedy:

Code: 863

Description: HDD data read failure
The data written to the HDD cannot be read normally, due to bad sectors generated during operation.
Causes: • HDD defective
Remedy:

Code: 864

Description: HDD data CRC error
During HDD operation, the HDD cannot respond to a CRC error query. Data transfer did not execute normally while data was being written to the HDD.
Causes: • HDD defective
Remedy:
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie