• Code: 0107
• Description: Unset up of the Linear Encoder
  Linear Encoder Setup has not been done.
• Causes: Linear Encoder Setup has not been done.

• Code: 0108
• Description: Wiper Unit Protection Error
  Even though the machine carries out the regular movement, the output of the Wiper Height Sensor does not reach the expected value.
• Causes: Disorder of Wiper Height Sensor Fault of Wiper Unit Fault of Wiper Height Sensor Cut-line or short-circuit of Cable and Flexible Cable

• Code: 0109
• Description: Wiper Protection Error
  Even though the machine carries out the regular movement, the output of the Wiper Sensor does not reach the expected value.
• Causes: Disorder of Wiper Sensor Fault of Wiper Unit Fault of Wiper Sensor Cut-line or short-circuit of Cable and Flexible Cable

• Code: 0110
• Description: Linear Encoder Error
  Input value from Linear Encoder is not changed when Linear Encoder is set up the Origin. When Motor stops during printing, Motor does not complete the movement which is supposed to be done.
• Causes: Read error of Linear Encoder Read error of Encoder on Scan Motor side Wire is not fixed to Head Carriage firmly.

• Code: 0111
• Description: Tool / Crop Error
  This error occurs when the machine performs the Auto Crop Mark Detection or the Auto Print / Cut adjustment without the Tool / Crop Mark Sensor Adjustment.
• Causes: Tool / Crop Mark Sensor Adjustment has not been performed.

• Code: Err
• Description: The SV or the set values of some parameters have been changed without any operation.
• Causes: Parameter settings of [P-SL], [P-SU] and [P-n2] are not correct. Parameter settings of [P-SL], [P-SU] and [P-n2] are not correct. When the set value of [P-SU] is larger than 1000, "1" will be registered for [P-DP].

• Code: UUUU, LLLL
• Description:
• Causes: Parameter setting of [P-n2] is not correct. The Cable of the Thermistor which is fixed to the Controller is broken or short-circuit. The Cable of the Thermistor which is fixed to the Controller is loose. The Thermistor is broken. Parameter settings of [P-SL], [P-SU] and [P-n2] are not correct.