Code :

Code: C3-1110, C3-1120, C3-1140
Display: Prepare new imaging unit. Replace with new imaging unit. End of life, Replace with new imaging unit
Description: The remaining life of the imaging unit is less than 10% of its life. / The remaining life of the imaging unit is less than 0% of its life.
Remedy: Check the life remaining of the imaging unit. If its life is at the end, turn the machine off and replace the imaging unit with new one.

Code: C3-1312
Display: Imaging Unit Failure: #C3-1312. Install imaging unit again.
Description: Toner sensor is defective. The machine can’t detect the sensor signal in the imaging unit normally.
Remedy: 1) Install the genuine samsung imaging unit. 2) If the imaging unit is already installed, check the following. • Reinstall the toner cartridge and imaging unit. • Check if the CRUM connector is normal. • Turn the machine off then on.

Code: C3-1330
Display: Imaging Unit Failure: #C3-1330. Install imaging unit again.
Description: The imaging unit is not installed properly.
Remedy: 1) Open the front cover. 2) If the imaging unit is not installed, install it. Try to test the machine again. 3) If the imaging unit is installed, remove it. Check if the modular jack is contaminated or broken. 4) Clean the modular jack or replace the imaging unit. 5) If it is OK, check the CN22 harness connection on the main board. 6) If the harness is defective, replace it. 7) Turn the machine off then on. Try to test the machine.

Code: H1-1210, H1-1310
Display: Paper Jam in Tray#
Description: A jammed paper has occurred in the option cassette. (SCF unit)
Remedy: 1) Remove the jammed paper. If the problem persists, check the followings. 2) Check if the paper is loaded in the SCF tray properly. 3) Check if the roller is defective or worn out. 4) Check if the Empty/ Pick up/ Regi-Act sensor is working properly. 5) Check if the main board/ motor/ clutch connector are connected properly. 6) Check if the AS-SPRING_ES is deformed or assembled properly. 7) Check if the Press D-cut of the Gear-Lifting is broken. 8) If the problem persists after checking No. 1-7, replace the SCF main board. 9) If the problem persists, replace the Drop connector harness.

Code: H1-1222, H1-1322
Display: Tray# cassette is pulled out. Insert it properly.
Description: A optional cassette (SCF) is pulled out.
Remedy: 1) Check if the optional cassette is inserted properly. Remove the cassette then re-install it. 2) Check if the Signal-Switch is deformed or broken. If it is defective, replace it.

Code: H1-1230, H1-1240, H1-1330
Display: Input System Failure: #. Check Tray # connection. Tray # is not installed. Install the tray.
Description: The communication error between the machine and option cassette has occurred.
Remedy: 1) Turn the machine off then on. 2) Check if the option tray harness on main board is connected properly. Reconnect or replace the harness. 3) Check if the SCF draw connector is broken. 4) If the problem persists, replace the SCF main board.

Code: H1-1252, H1-1352
Display: Paper Empty in Tray#
Description: Paper in the optional cassette is empty.
Remedy: 1) Check if the paper in optional cassette is loaded. Load the paper. 2) Check if the empty actuator and empty sensor are assembled properly. 3) If the empty actuator is defective, replace it. 4) If the problem persists after replacing the empty actuator, replace the empty sensor.

< 1 2 3 4 5 > Last ›