Danh mục sản phẩm

Code :

Code: 25
Display: Network Problem Network cable is not connected. Check it
Description: Network cable is not connected.
Remedy: Connect the machine to the network with a network cable.

Code: 26
Display: Network Problem Network card is not installed. Check it
Description: Network card is not installed.
Remedy: 1. Turn off the machine and reboot it. 2. Replace the PBA-MAIN.

Code: 27
Display: Output bin Full Output bin Full. Remove printed paper
Description: The document output tray is full.
Remedy: Remove the paper from output tray.

Code: 28
Display: Original paper Jam Original paper jam inside of scanner. Remove Jam
Description: The load original has jammed in the document feeder.
Remedy: 1. Remove all documents on DADF. 2. Open the DADF door and remove the jammed paper.

Code: 29
Display: Paper Jam in MP tray
Description: Paper has jammed in the feeding area of the MP tray.
Remedy: 1. Remove the paper from MP tray. 2. If pick up roller does not rotate , check the pick up clutch. 3. If Pickup roller is rotating but the paper is not feeding, replace the pick up rubber. 4. Check the feed sensor. If it is defective, replace it.

Code: 30
Display: Paper Jam in tray1
Description: Paper has jammed in the feeding area of the tray1.
Remedy: 1. Remove the paper from tray1. 2. If pick up roller does not rotate , check the pick up clutch. 3. If pickup roller is rotating but the paper is not feeding, replace the pick up rubber. 4. Check the feed sensor. If it is defective, replace it.

Code: 31
Display: Paper Jam in tray2
Description: Paper has jammed in the feeding area of the tray2.
Remedy: 1. Remove the paper from tray2. 2. If pick up roller does not rotate , check the pick up clutch. 3. If pickup roller is rotating but the paper is not feeding, replace the pick up rubber. 4. Check the feed sensor. If it is defective, replace it.

Code: 32
Display: Paper Empty in MP Paper is empty in MP tray. Load paper
Description: There is no paper in the MP tray.
Remedy: 1. Load the papers in the MP Tray. 2. Check the MP empty sensor on EDC mode. 3. If it is defective, replace it.

‹ First < 2 3 4 5 6 7 8 >

0