• Code: 201.10
• Display: 201.10
• Description: Input sensor flag broke early. Possible causes: • Paper jam leaving page over sensor • Defective input sensor • Faulty system card
• Remedy: • Check for anything in the paper path that might cause the paper to jam.

• Code: 201.21
• Display: 201.21
• Description: Cartridge motor 1 (top) or cartridge motor 2 (bottom) has stalled. Possible causes: • Faulty cable/connector • Faulty cartridge motor • Faulty system card
• Remedy: • Check for anything in the paper path that might cause the paper to jam.

• Code: 201.23
• Display: 201.23
• Description: Special case. Possible cause: • System card code failure
• Remedy: • POR the printer. Replace the system card.

• Code: 201.24
• Display: 201.24
• Description: A 201.08 jam occurred and was not cleared. Possible cause - Failure to open and close the top access door.
• Remedy: This error is generated as a protection for possible paper wrap in the fuser. Open the top access door, and check for a paper jam. Close the top access door.

• Code: 202.02
• Display: 202.02
• Description: Exit sensor is made when printer tries to print from an idle state. Possible causes: • Damaged paper exit sensor or paper exit sensor flag • Damaged fuser autoconnect • Faulty fuser DC cable connection • Faulty fuser • Faulty system card
• Remedy: • Check for anything in the paper path that might cause the paper to jam. • The fuser exit sensor may not be functioning properly.

• Code: 202.12
• Display: 202.12
• Description: Exit sensor broke early. Possible causes: • Damaged paper exit sensor or paper exit sensor flag • Faulty fuser • Faulty system card
• Remedy: The fuser exit sensor may not be functioning properly.

• Code: 202.13
• Display: 202.13
• Description: Exit sensor never broke. Possible causes: • Damaged paper exit sensor or paper exit sensor flag • Faulty fuser • Faulty system card • Faulty output bin flag
• Remedy: • Check output bin flag on fuser for proper operation. Ensure that paper is not hanging on the flag. • The fuser exit sensor may not be functioning properly.

• Code: 202.17
• Display: 202.17
• Description: Exit sensor is made when the printer powers up or covers are closed. Possible causes: • Damaged paper exit sensor or paper exit sensor flag • Damaged fuser autoconnect • Faulty fuser DC cable connection • Faulty fuser • Faulty system card
• Remedy: • Check for anything in the paper path that might cause the paper to jam. • The fuser exit sensor may not be functioning properly.