Description: Drum New CRU Installation Fail During the developing powder installation mode after installing the Drum Cartridge, the ATC Measured Value is found to be abnormal. (Seal not removed)
Remedy: 1. Remove the developing powder seal from the Drum Cartridge. 2. If the problem persists after removing the seal, replace the Drum Cartridge. (PL 8.1)
Description: Drum New CRU Installation Fail Exceeds Thresholding Times The number of developing powder installation mode executions has exceeded the upper limit.
Remedy: Replace it with the correct Drum Cartridge. (PL 8.1)
Description: No Drum Cartridge The Drum Cartridge cannot be detected.
Remedy: 1. Turn the power OFF and ON. 2. Turn OFF the power and check the following: • The Drum CRUM PWB and Drum Cartridge CRUM connection terminals in the Drum Cartridge for poor contact. • The connection between the Drum Cartridge J615 and the Drum CRUM PWB JA for open circuit, short circuit, and poor contact. • The connection between the ESS/MCU PWB J426 and the Drum Cartridge P615 for open circuit, short circuit, and poor contact. 3. If no problem is found, replace the following parts in sequence: • Drum Cartridge (PL 8.1) • ESS/MCU PWB (PL 18.1)
Description: Controller Logic Fail • A software defect that cannot be ignored was found in the Controller software. • The CPU has rebooted due to the occurrence of an exception.
Remedy: 1. Turn the power OFF and ON. 2. Install a Controller Firmware with the correct version.
Description: Controller NVM Data Defect Any of the following was detected: • The On Board NVM data of the Controller is corrupted. • The On Board NVM of the Controller is not installed. • Any one of the Print Counter has reached its maximum value. • The number of times the NVM can be changed has reached its limit. NOTE: If this Fault reoccurrs after performing Data Backup/Restore, perform Data Restore again. (Perform NVM Matching (NVM[621-400]) in the CE Mode.)
Remedy: 1. Turn the power OFF and ON. 2. Perform NVM Initialize in the CE Mode. (Refer to [6.4.2.5 NVM Initialize].)
Nhận ưu đãi sớm nhất khi chương trình diễn ra
Đăng ký nhận bản tin
Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này.
Chính sách cookie
Những cookie này là cần thiết để trang web hoạt động đúng cách.
Những cookie này giúp chúng tôi hiểu cách khách truy cập tương tác với trang web.
Những cookie này được sử dụng để cung cấp quảng cáo cá nhân hóa.