• Code: 013-212
• Description: Booklet Staple Move Position SNR ON Fail RAP Booklet Staple Move Position SNR does not turn on within designated time period
• Remedy: Check the Staple Move Home Sensor for the following: • wiring • connections • operation • voltage

• Code: 013-213
• Description: Booklet Staple Move Position SNR OFF Fail RAP Booklet Staple Move Position SNR does not turn off within designated time period
• Remedy: Check the Staple Move Home Sensor for the following: • wiring • connections • operation • voltage

• Code: 013-220
• Description: Booklet Fold Detect Fail RAP Upon turning power on, a problem is detected in Booklet Unit or Fold Unit
• Remedy: Check the Book Folder for the following: • operation • binding • ware • debris

• Code: 013-306
• Description: Booklet Safety SW Open RAP Upon turning power on, a problem is detected in Booklet Unit or Fold Unit
• Remedy: Check the Booklet Safety Switch for the following: • wiring • connections • operation • voltage

• Code: 013-307
• Description: Booklet Cover Open RAP Upon turning power on, a problem is detected in Booklet Unit or Fold Unit
• Remedy: Check the Booklet Cover Switch for the following: • wiring • connections • operation • voltage

• Code: 024-362
• Description: Page Sync Illegal Start RAP During IOT output, before the output data was written to FIFO Full, Page Sync became active. Even though the system is not easily affected by noise, extreme noise may be the cause.
• Remedy: Check that P/Js 402 on the MCU PWB (PL 9.1) and P/J 310 on the ESS PWB (PL 9.2) are securely connected. If the problem persists reload Firmware (ADJ 9.3.1).

• Code: 024-363
• Description: Page Sync Illegal Stop RAP During IOT output, before output in the specified size, Page Sync was disabled.
• Remedy: Check that P/Js 402 on the MCU PWB (PL 9.1) and P/J 310 on the ESS PWB (PL 9.2) are securely connected. If the problem persists reload Firmware (ADJ 9.3.1).

• Code: 024-364
• Description: DMA Transfer RAP Reduction/enlargement failed to access the data in Direct Memory Access.
• Remedy: NOTE: There is a high probability that the cause is faulty firmware or data corruption (DIMM or HDD). Reload Software (ADJ 9.3.1). If the problem persists perform Hard Disk Diagnostic Program. If the problem persists, replace the DIMM (PL 11.2). If the problem persists, replace the HDD (PL 11.2).