Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Canon imageCLASS LBP7780Cdn

Code: E000-0000

Description: Fixing startup failure
Causes: The detection temperature of the main thermistor did not increase after start of the power distribution to the heater.
Remedy: • Replace the fixing assembly. • Replace the DC controller PCB

Code: E001-0000

Description: Abnormal high temperature in fixing
Causes: The main thermistor detected a temperature of higher than 255 degree C.
Remedy: • Replace the fixing assembly. • Replace the DC controller PCB.

Code: E001-0001

Description: Abnormal high temperature in fixing
Causes: The sub thermistor detected a temperature of higher than 290 degree C.
Remedy: • Replace the fixing assembly. • Replace the DC controller PCB.

Code: E001-0004

Description: Abnormal high temperature in fixing
Causes: The sub thermistor 2 detected a temperature exceeding a specified temperature.
Remedy: • Replace the fixing assembly. • Replace the DC controller PCB.

Code: E003-0000

Description: Abnormal low temperature in fixing
Causes: The main thermistor detected a temperature of lower than 120 degree C for more than 1 second when 20 seconds elapsed after start of the power distribution to the heater.
Remedy: • Replace the fixing assembly. • Replace the DC controller PCB.

Code: E003-0001

Description: Abnormal low temperature in fixing
Causes: The sub thermistor detected a temperature of lower than 80 degree C for more than 2 seconds when 20 seconds elapsed after start of the power distribution to the heater.
Remedy: • Replace the fixing assembly. • Replace the DC controller PCB.

Code: E003-0004

Description: Abnormal low temperature in fixing
Causes: The sub thermistor 2 detected a temperature lower than a specified temperature
Remedy: • Replace the fixing assembly. • Replace the DC controller PCB.

Code: E004-0000

Description: Fixing assembly drive circuit failure
Causes: 43 to 57Hz could not be detected continuously for more than 5 seconds when zero cross detection started.
Remedy: • Check the contact of the connector between the fixing assembly and the low-voltage power supply PCB. • Replace the low-voltage power supply PCB.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie