Code :

Code: E013-0000
Description: Residual toner feed motor failure
Causes: Residual toner feed motor failure
Remedy: • Check the contact of the connector between the Residual toner feed motor (J89L) and the DC controller PCB (J137). • Replace the Residual toner feed motor

Code: E014-0000
Description: Fixing motor failure
Causes: Fixing motor startup error The target speed was not reached within a specified time after startup of the motor
Remedy: • Check the contact of the connector between the fixing motor (J516) and the DC controller PCB (J81). • Check the gear between the fixing motor and the fixing assembly. • Replace the fixing motor.

Code: E014-0001
Description: Fixing motor failure
Causes: Fixing motor rotation error The motor rotated out of the target speed during rotation after the target speed was reached.
Remedy: • Check the contact of the connector between the fixing motor (J516) and the DC controller PCB (J81). • Check the gear between the fixing motor and the fixing assembly. • Replace the fixing motor.

Code: E015-0000
Description: Error in the developing disengagement movement
Causes: Developing disengagement motor failure • The standard flag was not detected even when driving was performed for 1000ms after rotation of the motor. • The standard flag was not detected even when driving was performed for 8000ms at the time of switching from the full-color position to "all disengagement". • The standard flag was not detected even when driving was performed for 3000ms at the time of switching from the monochrome position to "all disengagement".
Remedy: • Reconnect the connector J518 of the developing disengagement motor, the connector J1005 on the driver PCB, and the connector J91 on the DC controller PCB. • Check the condition of the developing disengagement sensor in the sensor monitor mode. If a failure is found, replace the developing disengagement sensor assembly. • Execute the developing assembly engagement/disengagement drive test in the actuator drive mode. If the developing assembly does not perform engagement/disengagement, replace the developing disengagement motor.

Code: E015-0001
Description: Error in the developing disengagement movement
Causes: Cassette 1 lift up motor error
Remedy: • Reconnect the connector J151 on the DC controller PCB and the relay connector J742. • Check the cassette media stack surface sensor in the sensor monitor mode. If a failure is found, replace the lifter drive unit. • Replace the lifter drive unit.

Code: E015-0002
Description: Error in the developing disengagement movement
Causes: Cassette 2 lift up motor error
Remedy: • Reconnect the connector J2003 on the paper feeder driver PCB and the relay connector J702. • Check the paper feeder media stack surface sensor in the sensor monitor mode. If a failure is found, replace the pickup unit. • Reconnect the connector J2006 on the paper feeder driver PCB. • Replace the lifter drive unit.

< 1 2 3 4 5 6 > Last ›