• Code: E010-0001
• Description: The rotation of the main motor is faulty.
  Detection is executed every 100 msec after the start of motor rotation; however, the drive detection signal is absent for 2 sec.
• Remedy: Replace the main motor. Replace the DC controller PCB.

• Code: E010-0002
• Description: The rotation of the main motor is faulty.
  During motor rotation, detection is executed every 100 msec; however, the drive signal is absent 5 times in sequence.
• Remedy: Replace the main motor. Replace the DC controller PCB.

• Code: E014-0001
• Description: The rotation of the fixing motor is faulty.
  Detection is executed every 100 msec after the start of motor rotation; however, the drive detection signal is absent for 2 sec.
• Remedy: Replace the fixing motor. Replace the DC controller PCB.

• Code: E014-0002
• Description: The rotation of the fixing motor is faulty.
  During motor rotation, detection is executed every 100 msec; however, the drive signal is absent 5 times in sequence.
• Remedy: Replace the fixing motor. Replace the DC controller PCB.

• Code: E019-0000
• Description: The waste toner case is full, or the waste toner case full sensor is faulty.
  When the waste toner case is identified as being full for 2000 prints continuously, an alert is issued; thereafter, the case is identified as being full continuously for 100 prints.
• Remedy: Replace the waste toner sensor. Replace the DC controller PCB.

• Code: E020-0000
• Description: The path between the sub hopper and the developing assembly is clogged with toner
  The developing assembly toner sensor detects the absence of toner, while the sub hopper toner sensor detects the presence of toner. With the developing clutch turned on, the hopper feedscrew motor is rotated for 1 sec intermittently 194 times; still, the developing assembly toner sensor does not detect the presence of toner
• Remedy: Replace the developing assembly toner sensor. Replace the sub hopper toner sensor. Replace the DC control PCB

• Code: E024-0000
• Description: The developing assembly connector is disconnected/Disconnection of Toner sensor.
  The connection detection signal is absent continuously for 100 msec
• Remedy: Replace the developing assembly toner sensor. Connect the connector. Replace the DC controller PCB.

• Code: E024-0001
• Description: The developing assembly connector is disconnected/Disconnection of Toner sensor.
  Disconnection of the wire used for detecting the connection of the toner level sensor is found. When the disconnection of the wire used for detecting the connection of the toner level sensor has been detected for 7.5 min without interruption (12.5 min in the manual /envelop cassette feeding). When the disconnection of the wire used for detecting the connection of the toner level sensor has been detected for 12.5 min without interruption.
  -iR 3225
  When the disconnection of the wire used for detecting the connection of the toner level sensor has been detected for 7.5 min without interruption (12.5 min in the manual /envelop cassette feeding).
  -iR 3245/3235/3230
  When the disconnection of the wire used for detecting the connection of the toner level sensor has been detected for 12.5 min without interruption.
• Remedy: Correct the cable. Replace the sensor.