• Code: E514-0002
• Description: fault in stack delivery motor (Finisher-S1)
  When the stack retaining spacer is shifted from home position, the belt escape home position sensor does not go off within 1.5 sec.
• Remedy: Replace the finisher controller PCB. Replace the stack delivery motor. Check the stack delivery drive mechanism.

• Code: E514-0002
• Description: fault in trailing edge assist motor (External finisher)
  The home position sensor does not go on even after the trailing edge assist motor has rotated for a specific period of time.
• Remedy: Replace the finisher control PCB. Replace the trailing edge assist motor

• Code: E519-0001
• Description: Gear change motor error (External finisher)
  The home position sensor does not go off even when the gear change motor has rotated for a specific period of time.
• Remedy: Replace the finisher controller PCB. Replace the gear change motor. Check the gear change mechanism.

• Code: E519-0002
• Description: Gear change motor error (External finisher)
  The home position sensor does not go on even when the gear change motor has rotated for a specific period of time.
• Remedy: Replace the finisher controller PCB. Replace the gear change motor. Check the gear change mechanism.

• Code: E520-0001
• Description: The offset motor or the finisher controller PCB is faulty. The offset home position sensor is faulty (Finisher-S1).
  While the offset motor is in operation, drive was applied for 1000 msec for movement toward the home position sensor; however, the offset home position sensor does not go on.
• Remedy: Replace the offset motor. Replace the offset home position sensor. Replace the finisher controller PCB.

• Code: E520-0002
• Description: The offset motor or the finisher controller PCB is faulty. The offset home position sensor is faulty (Finisher-S1).
  While the offset motor is in operation, drive was applied for 1000 msec for movement away from the home position sensor; however, the offset home position sensor does not go off.
• Remedy: Replace the offset motor. Replace the offset home position sensor. Replace the finisher controller PCB.

• Code: E530-0001
• Description: Front alignment error (External finisher)
  The home position sensor does not go off even when the front alignment motor has been rotated for a specific period of time.
• Remedy: Replace the finisher controller PCB. Replace the front alignment motor. Check the front aligning plate drive mechanism. Check the front alignment home position sensor.

• Code: E530-0002
• Description: Front alignment error (External finisher)
  The home position sensor does not go on even when the front alignment motor has been rotated for a specific period of time.
• Remedy: Replace the finisher controller PCB. Replace the front alignment motor. Check the front aligning plate drive mechanism. Check the front alignment home position sensor.