Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi HP Color LaserJet CP3525 — Trang 11/12

Code: 59.C0

Display: 59.C0 ERROR
Description: The developing-disengagement motor is defective.
Remedy: 1. Perform the disengagement motor component tests in the DIAGNOSTICS menu. 2. Reconnect the connectors J25 and J138 on the DC controller and J261 on the high-voltage power supply (lower). 3. Run the sensor test to monitor for developing home position (SR11) to test whether the sensor is functioning. If not, replace the sensor. 4. Replace the developingdisengagement motor.

Code: 59.F0

Display: 59.F0 ERROR
Description: The primary transfer-alienation motor has experienced an error.
Remedy: 1. Check to ensure the ITB is installed correctly. 2. Run a sensor test to verify that the primary transfer disengagement roller is functioning. If not replace the sensor (SR17). 3. Run the primary transfer drive test in actuator drive mode. If not functioning, replace the ITB

Code: 59.XY

Display: 59.XY ERROR
Description: A temporary printing error has occurred.
Remedy: Turn the product off then on.

Code: 60.03

Display: 60.03 ERROR
Description: The Tray 2 lifter motor (M7) (SR13) has experienced an error.
Remedy: 1. Check the Tray 2 paper-surface sensor (u) in the MANUAL SENSOR TEST 2 (O) submenu in the DIAGNOSTICS menu. 2. Reconnect the connectors of the lifter motor (J140) and the DC controller PCA (J112). 3. If the problem persists, replace the lifter drive assembly.

Code: 60.04

Display: 60.04 ERROR
Description: The Tray 3 lifter motor (M2) has experienced an error.
Remedy: 1. Check the Tray 3 paper-surface sensor (y) in the MANUAL SENSOR TEST 2 (P) submenu in the DIAGNOSTICS menu. 2. Reconnect the connector J405 and the J11 on the intermediate connector. 3. Reconnect connector J15 of the Tray 3 lifter motor (M2) and connector J404 of the pickup-feeder driver PCA. 4. If the problem persists, replace the optional paper feeder.

Code: 60.X

Display: 60.X ERROR
Description: The tray specified by X is not lifting correctly.
X values • 2 = Tray 2 • 3 = Tray 3
Remedy: Follow the instructions on the product control panel.

Code: 62

Display: 62 NO SYSTEM
Description: The product has an internal problem.
Remedy: Turn the product off and then on.

Code: 68.X

Display: 68.X PERMANENT STORAGE FULL
Description: The product NVRAM is full. Some settings saved in the NVRAM might have been reset to the factory defaults. Printing can continue, but some unexpected functions might occur if an error occurred in permanent storage.
X values • 0 = Internal memory • 1 = Removable disk
Remedy: Press the OK button to clear the message. If the message is not cleared, turn the product off, and then turn the product on.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie