Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi HP DesignJet 5000 — Trang 3/5

Code: 0A0050

Description: The Printer has detected a leak in the Tubes System before the life of the System.
Remedy: • Check for ink in the Ink Leak Detector and, if present, replace the complete Tubes System  • The Ink Leak Detector could have been trigggered due to condensation in the Printer. Power OFF the Printer and allow the Printer to dry for 15 minutes. Power ON and check if the System Error Code has disappeared. • Replace the ISS PCA  WARNING Only replace one component at a time and check if the error has gone before replacing another component. Using this procedure you will be able to determine exactly which component failed.

Code: 0A0060

Description: The Printer has detected a leak in the Tubes System after the life of the System.
Remedy: • Check for ink in the Ink Leak Detector and, if present, replace the complete Tubes System  • The Ink Leak Detector could have been trigggered due to condensation in the Printer. Power OFF the Printer and allow the Printer to dry for 15 minutes. Power ON and check if the System Error Code has disappeared. • Replace the ISS PCA  WARNING Only replace one component at a time and check if the error has gone before replacing another component. Using this procedure you will be able to determine exactly which component failed.

Code: 0A0070

Description: The Backup EEROM contents stored in the Hard Disk Drive are not consistent with the ones required by the firmware.
Remedy: • Perform Backup EEROM  and ALL calibrations. Perform EEROM Setup  to reconfigure the Printer.

Code: 0B0000

Description: Bad Ambient Temperature measured.
Remedy: • Make sure that the Ambient temperature is within the allowed range (between 0 and 55 Degrees Centigrade). • Replace the Main PCA 

Code: 0B0001

Description: Bad Humidity read.
Remedy: Replace the Main PCA 

Code: 0B0002

Description: Bad IDS pressure read.
Remedy: • Check that the cable from the Ink Supply Station (ISS) PCA to the Ink Supply Station is correctly connected. • Check that the Air Pressurization System Sensor Cable is correctly connected and is NOT damaged. • Check all the tubes of the APS and make sure they are NOT pinched or damaged. • Faulty APS. Replace the APS  • If the error code continues, replace the Main PCA  WARNING Only replace one component at a time and check if the error has gone before replacing another component. Using this procedure you will be able to determine exactly which component failed.

Code: 0B0003

Description: ADC0 Internal channels check Failure.
Remedy: Replace the Main PCA 

Code: 0B0004

Description: APS Failure.
Remedy: • Check that the cable from the Ink Supply Station (ISS) PCA to the Ink Supply Station is correctly connected. • Faulty APS. Replace the APS  • If the error code continues, replace the Main PCA  WARNING Only replace one component at a time and check if the error has gone before replacing another component. Using this procedure you will be able to determine exactly which component failed.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie