Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi HP DesignJet 5500 — Trang 5/5

Code: 0B000D

Description: 24 V source test failure.
Remedy: Replace the Main PCA

Code: 0C0030

Description: Drop Detector Failure.
Remedy: • Check that the Drop Detector Cable is NOT broken or damaged. • Check that the Drop Detector cable is correctly connected to the Service Station Cable. • Remove the Drop Detector and make sure that there are no obstacles inside which are blocking the sensor. • Replace the Drop Detector Assembly  • If the System Error Code continues, replace the Main PCA  WARNING Only replace one component at a time and check if the error has gone before replacing another component. Using this procedure you will be able to determine exactly which component failed.

Code: 0C0032

Description: Drop Detector not Calibrated for all Printheads.
Remedy: • Perform the Service Station Calibration  • Replace the Drop Detector Assembly  • If the System Error Code continues, replace the Main PCA  WARNING Only replace one component at a time and check if the error has gone before replacing another component. Using this procedure you will be able to determine exactly which component failed.

Code: 0C0040

Description: Error in Printhead Drop Detection.
Remedy: • Recover the Printheads  • Replace the Drop Detector 

Code: 0C1001

Description: Primer Shutdown Error.
Remedy: • Check that the Primer Stepper-Motor Cable is NOT broken or damaged and that the Primer Arm moves freely from side to side. • Replace the Service Station  • If the Error Code continues, replace the Main PCA  WARNING Only replace one component at a time and check if the error has gone before replacing another component. Using this procedure you will be able to determine exactly which component failed.

Code: 0D0000

Description: No Media Profiles Available.
Remedy: • Download a media profile for the ink type being used.

Code: 0D0002

Description: Insufficient Memory to Initialize HPGL2/RTL.
Remedy: • The minimum memory required is 96 Mbytes so verify memory installed on the printer using the Statistics menu (refer to the User’s Guide).

Code: 0FXXXX

Description: A Firmware Error has occurred.
Remedy: • Power OFF and ON using the Printer Power Switch. • Report the error to the HP Response Center or the nearest HP Support Office. Have the following information ready: • Model and Serial Number of the printer. • Which firmware revision the printer is using (displayed during Printer initialization when powering ON). • The complete error number. • The Service Configuration Print if possible  • The Current configuration sheet. • Which software application the customer is using (name, version, etc.).
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie