Code :

Code: 41:10
Description: Electrical fault at the Media Axis motor. Electrical fault in Media Axis motor.
Remedy: • Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the power cord and power On the Printer. • Check that the Media-Axis Motor cable is not damaged and is correctly connected to the PrintMech PCA. • Replace the Media-Axis Motor . • If the System Error continues, replace the PrintMech PCA

Code: 42:03
Description: Problem with the Scan Axis Motor. Electrical current limit in Scan Axis motor.
Remedy: • Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the power cord and power On the Printer. • Open the Window and check for any visible obstacles restricting the movement of the Carriage Assembly. If there is a wrinkled mass of media blocking the Carriage Assembly, then clear the obstruction. • Perform the Scan Axis Service Test. • Replace the Scan Axis Motor . • If the System Error continues, replace the PrintMech PCA .

Code: 42:10
Description: Electrical fault in the Scan Axis area. Electrical fault in Carriage Motor or starting the Scan Axis or Homing Scan Axis.
Remedy: • Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the power cord and power On the Printer. • Perform the Scan Axis Service Test. • Check that the Scan Axis Motor cable is not damaged and is correctly connected to the PrintMech PCA. • Replace the Scan Axis Motor . • If the System Error continues, replace the PrintMech PCA

Code: 43:10
Description: Problem with the Vacuum Fan. Vacuum Fan has failed.
Remedy: • Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the power cord and power On the Printer. • Perform the Vacuum Fan service test ËPage 142. • Check that the Vacuum Fan cbles are not damaged and are correctly connected to the Interconnect PCA. • Also check that the cables between the Interconnect PCA and the PrintMech PCA are not damaged and are correctly connected. • Replace the Interconnect PCA . • Replace the Vacuum Fan . • If the System Error continues, replace the PrintMech PCA

Code: 44:10
Description: There is a problem with the Aerosol Fan.
Remedy: • Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the power cord and power On the Printer. • Check that the Aerosol Fan cable is not damaged and is correctly connected to the Interconnect PCA. • Replace the Aerosol Fan .. If the System Error continues, replace the Interconnect PCA .

Code: 44:11
Description: Connection problem with the Aerosol Fan
Remedy: • Check that the Aerosol Fan cable is not damaged and is correctly connected to the Interconnect PCA. • Replace the Aerosol Fan .

Code: 45.01:00
Description: Rewinder Servo Shutdown. Problem with the Rewinder servo
Remedy: • Check the spindle is correctly inserted into the Printer. • Load the substrate again making sure that the media is straight and that a ebubblef is not formed on the media path. Do not rewind manual the media when the printer is checking the roll. • Check that the Spindle is not damaged and the gear at the end the spindle is correctly attached. • Perform 3.1 Rewinder Motor service test Ëpage 133. • Check the Rewinder motor cable is not damaged and is correctly connected. • Replace the Right Roll Housing assembly . • Replace the Rewinder Motor .

Code: 45.02:10
Description: Rewinder inverse polarity. Rewinder inverse polarity. This message is only displayed when the printer is initializing
Remedy: Swap over the power cables of the Rewinder motor.