Description: Carriage servo shutdown. There is a problem with the carriage assembly.
Remedy: • Open the Window observing all safety precautions and check for any visible obstacles restricting the movement of the Carriage Assembly. If there is a wrinkled mass of media inside the paper path, lift the Pinchwheels (using the Media Lever) and clear the obstruction. • Check that the Carriage Stopper is correctly installed Ëpage 412. • Perform the gScan Axish Diagnostic , depending on the result of the test, you may need to replace the following parts: • Scan Axis Motor Ëpage 419. • Encoder Strip Ëpage 399. • Check the cables are correctly connected between the PrintMech PCA and the Scan Axis Motor. • If the error continues, replace the Scan Axis Motor .
Description: Unable to pressurize the IDS. The IDS must be pressurized but the requested pressure is not achievable in the time given (120 seconds).
Remedy: • Perform the APS service test ËPage 146 • Check the air pumps are correctly connected. • Check the cables from the PrintMech to the Air Pump are connected and not damaged. • Check that the air tubes connected to the air pressure sensor are not pinched and are correctly connected. • Check that the air tubes are connected, as this issue could cause this system error to be displayed • Check the Primer air tubes are connected and not damaged. • Tap on the relief valve with a screw driver several times to release it from a pressure blockage. • Remove ALL the Ink Cartridges and reinstall them one by one in to the Printer. • Replace the APS Assembly . • Replace the ISS PCA
Nhận ưu đãi sớm nhất khi chương trình diễn ra
Đăng ký nhận bản tin
Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này.
Chính sách cookie
Những cookie này là cần thiết để trang web hoạt động đúng cách.
Những cookie này giúp chúng tôi hiểu cách khách truy cập tương tác với trang web.
Những cookie này được sử dụng để cung cấp quảng cáo cá nhân hóa.