Code :

Code: 50:03
Description: Internal electrical connection problem. FW error in DSP or Engine code or link is broken between PCAs.
Remedy: • There is a tendency for this system error to being displayed because of cables becoming disconnected. Check all relevant cables are correctly connected, especially the cables from the OMAS Controller and the Main PCA and the Sausalito PCA. • Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the power cord and power On the Printer. • Check that the Printer has the latest Firmware version, if not, update the firmware to the latest version. • Replace the OMAS Controller Card • Replace the OMAS Module

Code: 50:11
Description: Media navigation problem. Navigation problems, caused by a mis-positioned sensor, DOF or skew issue.
Remedy: • Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the power cord and power On the Printer. • Check that the Printer has the latest Firmware version, if not, update the firmware to the latest version. • Check that the OMAS Module cable is not damaged and is correctly connected to the OMAS Controller PCA. • Replace the OMAS Controller Card • Replace the OMAS Module

Code: 50:14
Description: Firmware version mis-match. FW version mismatch between the controller fw and the version of the file in the Engine disk.
Remedy: • Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the power cord and power On the Printer. • Check that the Printer has the latest Firmware version, if not, update the firmware to the latest version. • Replace the OMAS Controller Card

Code: 51.01:10
Description: Problem with the Service Station door sensor. Error detected with the sensor on the Service Station Door.
Remedy: • Check that the Printhead Maintenance Cartridge Door Sensor cable is not damaged and is correctly connected to the Interconnect PCA. • Perform the Sensors service test . • Replace the Printhead Maintenance Cartridge Door Sensor .

Code: 51:10
Description: An error has been detected with the Window Lock Sensor. Error detected with the sensor on the Window.
Remedy: • Check that the Window Sensor cable is not damaged and is correctly connected to the Interconnect PCA. • Check the Window sensor locks are activating the Window Lock Sensor. • Replace the Left and Right Window Lock Sensor & page 347.

Code: 52:01
Description: A problem with the Drop Detector. Drop Detector fiber detected.
Remedy: • Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the power cord and power On the Printer. • Check that the Ink Funnel is correctly installed. Use the eReplace Ink Funnelf process to access the funnel. • Check that there is no obstructions in the funnel, such as media which would block the detector signal. • Replace the Drop Detector .

Code: 52:10
Description: A problem with the On/Off switch in the Drop Detector. Drop Detector switch On/Off failure.
Remedy: • Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the power cord and power On the Printer. • Check that the Drop Detector cable is not damaged and is correctly connected to the Service Station cable. • Check that the Service Station cable is not damaged and is correctly connected to the Interconnect PCA. • Replace the Drop Detector . • If the System Error continues, replace the Interconnect PCA . • Replace the Sausalito PCI PCA .

Code: 53:10
Description: Problem with the Media sensor. An error has been detected with the Media sensor.
Remedy: • Check that the Media Sensor cable is not damaged and is connected correctly to the Interconnect PCA. • Perform the Substrate Path Sensor service test . • Replace the Media Sensor .