Code :

Code: 45:03
Description: Rewinder servo shutdown
Causes: The Rewinder servo has shut down.
Remedy: 1. Switch the power off at the rear of the printer, wait briefly, then switch it back on again. 2. Open the Window and check for any visible obstacles restricting the movement of the Drive Roller. If there is a wrinkled mass of substrate inside the substrate path, lift the Pinch Wheels and clear the obstruction. 3. Replace the Rewinder Motor Module.

Code: 45:10
Description: Rewinder fault
Causes: Rewinder fault.
Remedy: 1. Switch the power off at the rear of the printer, wait briefly, then switch it back on again. 2. Replace the Rewinder Motor Module.

Code: 46:03
Description: Primer servo shutdown
Causes: The Primer servo has shut down.
Remedy: 1. Check that the Primer Arm is not damaged and that there are no obstacles in its way. 2. Switch the power off at the rear of the printer, wait briefly, then switch it back on again. 3. Replace the Primer Assembly.

Code: 46:10
Description: Primer test distance failed
Causes: Primer test distance failed.
Remedy: 1. Check that the Primer arm is not damaged and that there are no obstructions in the way. 2. Switch the power off at the rear of the printer, wait briefly, then switch it back on again. 3. Replace the Primer Assembly.

Code: 50.1:10
Description: OMAS communication failure
Causes: There has been a communication error with the Optical Media Advance Sensor (OMAS).
Remedy: 1. Switch the power off at the rear of the printer, wait briefly, then switch it back on again. 2. Check that the printer has the latest firmware version. If not, update the firmware to the latest version. 3. Check that the OMAS Controller to OMAS Sensor cable is not damaged and is correctly connected to the OMAS Controller Card and the OMAS Module. 4. Replace the OMAS Module.

Code: 50.2:10
Description: OMAS Controller Card communication failure
Causes: There has been a communication error with the OMAS Controller Card.
Remedy: 1. Switch the power off at the rear of the printer, wait briefly, then switch it back on again. 2. Check that the printer has the latest firmware version. If not, update the firmware to the latest version. 3. Replace the OMAS Controller Card.

Code: 50.3:11
Description: Main PCA to OMAS Controller cable not connected
Causes: The Main PCA to OMAS Controller cable does not seem to be connected.
Remedy: 1. Check that the Main PCA to OMAS Controller cable is not damaged. 2. Check that the Main PCA to OMAS Controller cable is correctly connected to the Main PCA and to the OMAS Controller Card.