Description: The job is reaching the printer too slowly
Causes: The job is reaching the printer too slowly. The printer cancels the job if there are long pauses of more than 20 s.
Remedy: 1. Make sure that a 1 Gigabit Ethernet card is correctly installed in the computer with the RIP. 2. Check the RIP for any error messages. Check that the computer with the RIP is working correctly and has the minimum specification required by the RIP. Check that the hard disk is neither full nor excessively fragmented. 3. Check whether the option RIP while printing is enabled. This option can cause slow printing if the computer is not sufficiently powerful. 4. Try reducing the resolution of the job or increasing the number of passes.
Causes: Input/Output problem through an unknown port.
Remedy: 1. Switch the power off at the rear of the printer, wait briefly, then switch it back on again. 2. Check that the LAN cable is connected. 3. Check that the printer has the latest firmware. If not, upgrade to the latest firmware. 4. Replace the Formatter PCA.
Remedy: 1. Switch the power off at the rear of the printer, wait briefly, then switch it back on again. 2. Resend the firmware update file to the printer.
Description: Embedded Web Server internal software error
Causes: Embedded Web Server internal software error.
Remedy: 1. Switch the power off at the rear of the printer, wait briefly, then switch it back on again. 2. Check that the printer has the latest firmware version. If not, update the firmware to the latest version.
Causes: The printer has reached an end-of-roll condition: substrate moving, but input spindle not rotating.
Remedy: 1. If the roll is not finished, unload and reload the substrate. 2. Load a new roll. 3. Check that the substrate is not slipping on the spindle.
Remedy: 1. Switch the power off at the rear of the printer, wait briefly, then switch it back on again. 2. Check that the printer has the latest firmware version. If not, update the firmware to the latest version. 3. Perform Hard Disk Recovery.
Remedy: 1. Switch the power off at the rear of the printer, wait briefly, then switch it back on again. 2. Check that the printer has the latest firmware version. If not, update the firmware to the latest version. 3. Try using different selections in the RIP to print the image. 4. Perform Hard Disk Recovery. 5. For more detailed information on troubleshooting the 79:04 system error.
Nhận ưu đãi sớm nhất khi chương trình diễn ra
Đăng ký nhận bản tin
Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này.
Chính sách cookie
Những cookie này là cần thiết để trang web hoạt động đúng cách.
Những cookie này giúp chúng tôi hiểu cách khách truy cập tương tác với trang web.
Những cookie này được sử dụng để cung cấp quảng cáo cá nhân hóa.