Code :

Code: 50:14
Description: Firmware version mismatch
Causes: Firmware version mismatch between the OMAS Controller Card and the Hard Disk Drive.
Remedy: 1. Check that the printer has the latest Firmware version. If not, update the firmware to the latest version. 2. Replace the OMAS Controller Card.

Code: 52:01
Description: A problem with the Drop Detector
Causes: Drop Detector fiber detected.
Remedy: 1. Check that the Ink Funnel is correctly installed. Use the ¡¥Replace Ink Funnel¡¦ process to access the funnel. 2. Check that there are no obstructions in the funnel, such as substrate, which would block the detector signal. 3. Replace the Drop Detector.

Code: 52:10
Description: A problem with the On/Off switch in the Drop Detector
Causes: Drop Detector switch On/Off failure.
Remedy: 1. Switch the power off at the rear of the printer, wait briefly, then switch it back on again. 2. Check that the Drop Detector cable is not damaged and is correctly connected to the Service Station cable. 3. Check that the Service Station cable is not damaged and is correctly connected to the Interconnect PCA. 4. Replace the Drop Detector. 5. Replace the Interconnect PCA. 6. Replace the Engine PCA.

Code: 53.1:10
Description: Media Sensor error
Causes: An error has been detected in the Media Sensor.
Remedy: 1. Switch the power off at the rear of the printer, wait briefly, then switch it back on again. 2. Check that the Media Sensor cable is not damaged and is connected correctly to the Interconnect PCA. 3. Replace the Media Sensor.

Code: 53.1:11
Description: Media Sensor cable not connected
Causes: The Media Sensor cable does not seem to be connected.
Remedy: Ensure that the Media Sensor cable is not damaged and is connected correctly to the Interconnect PCA.

Code: 54:10
Description: Media Lever Sensor error
Causes: An error has been detected in the Media Lever Sensor.
Remedy: 1. Switch the power off at the rear of the printer, wait briefly, then switch it back on again. 2. Check that the Media Lever Sensor cable is not damaged and is correctly connected to the Interconnect PCA. 3. Replace the Media Lever Sensor.

Code: 55:10
Description: Line Sensor communication failure
Causes: The printer cannot communicate with the Line Sensor.
Remedy: 1. Switch the power off at the rear of the printer, wait briefly, then switch it back on again. 2. Replace the Line Sensor.

Code: 56:01
Description: Incorrect readings from Substrate Encoder
Causes: Incorrect readings from Substrate Encoder.
Remedy: 1. Switch the power off at the rear of the printer, wait briefly, then switch it back on again. 2. Perform Substrate Drive diagnostics. 3. Replace the Encoder Disc and Sensor.