Description: The paper path between the MFP and the output device is open and must be closed before printing can continue.
Remedy: 1. If you have a 3-bin mailbox installed, make sure the jam-access door is closed. 2. If you have a stapler/stacker installed, make sure the staple cartridge is snapped into position and that the staple-cartridge door is closed.
Description: The standard output bin was detached when the MFP was turned on, or the cable on the stapler/stacker or the 3-bin mailbox is not connected to the MFP.
Remedy: Turn the MFP off. If you are using the stapler/stacker or the 3-bin mailbox, make sure that the cable is connected to the MFP. Reattach the output bin, and then turn the MFP on. Observe the LED on the output device. If the message persists, verify that connector J65 on the DC controller is firmly seated. Replace SW103 if necessary.
Display: Reinsert Duplexer - To Continue Turn Off Then On
Description: The duplexer has been removed and must be reinstalled.
Remedy: 1. Reinsert the duplexer in the MFP. 2. If the message persists, the connection between the duplexer and the MFP might be faulty. Remove the duplexer and inspect the connectors: J44 on the DC controller and J151 on the duplexer. Replace the duplexer if necessary.
Description: The print cartridge has reached the end of its life. Printing cannot continue.
Remedy: 1. Replace the print cartridge. 2. If this message appears after you install a new print cartridge, the new print cartridge might be defective. Install a different cartridge. 3. Replace the DC controller PCA. 4. Replace the engine power-supply PCA.
Nhận ưu đãi sớm nhất khi chương trình diễn ra
Đăng ký nhận bản tin
Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này.
Chính sách cookie
Những cookie này là cần thiết để trang web hoạt động đúng cách.
Những cookie này giúp chúng tôi hiểu cách khách truy cập tương tác với trang web.
Những cookie này được sử dụng để cung cấp quảng cáo cá nhân hóa.