• Code: C9401
• Description: Exposure Lamp’s failure to turn ON
  • The output from the CCD Sensor is a predetermined value or less during CCD Sensor gain adjustment.
• Remedy: 1 Check the flat cable for proper connection and correct or change as necessary. 2 Change Scanner Assy. 3 Change PWB-C.

• Code: C9402
• Description: Exposure Lamp turning ON at abnormal timing
  • The average output value of the CCD Sensor with the Scanner at its standby position is a predetermined value or more at the end of a scan job.
• Remedy: 1 Check the flat cable for proper connection and correct or change as necessary. 2 Change Scanner Assy. 3 Change PWB-C.

• Code: CA051
• Description: Standard controller configuration failure
  • The controller of the printer control board (PRCB) is faulty.
• Remedy: 1 Check to see if the following setting has been correctly made: Service Mode?h - System - Image Controller Setting.?h If the setting is changed, be sure to turn OFF and ON the Main Power Switch. 2 Check the connectors of the MFP Control Board (PWB-MFPC) for proper connection and correct as necessary. 3 Change PWB-MFPC.

• Code: CA052
• Description: Controller hardware error
  • A controller hardware error is detected in the network I/F.
• Remedy:

• Code: CA053
• Description: Controller start failure
  • A controller start failure is detected in the controller interface.
• Remedy:

• Code: CB001 ... CB119
• Description: FAX Board Error
• Remedy:

• Code: CD004 ... CD011
• Description: HDD error
• Remedy:

• Code: CF001 ... CFF15
• Description: MFP Control Board error
• Remedy: