• Code: 200.12
• Description: Media detected at manual feeder sensor when not expected. Possible causes include user insert of media when motor is running or pre-staged media in the tray.
• Remedy: Carefully remove the tray and notice if the leading edge of the media is pointed upward and out of the tray. If so, then inspect the tray wear strips and replace if necessary. Inspect the input sensor flag and replace it if it does not rotate freely or is too loose.

• Code: 200.13
• Description: The input sensor is covered when the media is not expected (media in machine during warm-up).
• Remedy: Remove the toner cartridge/PC kit and inspect the input sensor flag. Replace the flag if necessary.

• Code: 200.14
• Description: Trailing edge cleared manual feed, but did not successfully debounce the sensor. Potential causes are a small gap or a bouncy manual feed sensor.
• Remedy: Remove the toner cartridge/PC kit. At the front, remove the upper front guide, and inspect the flag on the manual input sensor. If the flag is loose, then replace it. See “Media manual input sensor removal”.

• Code: 200.15
• Description: UNRECOVERABLE NO GAP JAM. Engine detected no gap at the manual feeder sensor, attempted to open the gap by stopping the feed rolls, but no trailing edge was ever seen at the input sensor.
• Remedy: Remove the toner cartridge/PC kit. At the front, remove the upper front guide, and inspect the flag on the manual input sensor. If the flag is loose, then replace it. See “Media manual input sensor removal”. Verify that the media is approved. Inspect the wear strips in the input tray, and replace if necessary.

• Code: 200.16, 200.17
• Description: 200.16 Transport motor error detected 200.17 Took too long to ramp up transport motor
• Remedy: Main motor gear drive Main motor cable LVPS/HVPS Controller board Warning: Do not replace the operator panel and controller board at the same time. Each card contains the printer settings. When either of these cards is new, it obtains the settings from the other card. Settings are lost when both are new and replaced at the same time. Turn off the printer, and unplug the main motor cable at J19. Turn on the printer, and check for the following voltages at J19: Verify ground at pin 5 for both the card and cable. •If these voltages are correct, then check the main motor cable for continuity. - Remove the left side cover to access the connector on the motor. - If continuity exists on each wire, then replace the main motor gear drive which includes the motor. - If continuity does not exist on one or more of the wires, then call the next level of support. •If these voltages are not correct, then see “Controller board connector pin values”, or replace the controller board. See “Controller board removal”.

• Code: 200.18
• Description: Manual feeder sensor never became uncovered from the sheet ahead.
• Remedy: Remove the toner cartridge/PC kit. At the front, remove the upper front guide, and inspect the flag on the manual input sensor. If the flag is loose, then replace it. See “Media manual input sensor removal”.

• Code: 200.19
• Description: The media never reached the input sensor, but was detected at manual feeder sensor.
• Remedy: Remove the toner cartridge/PC kit, and inspect for debris in the paper path. Check the bottom of the PC kit for any obstructions. Remove the upper front guide, and inspect the pinch rollers.

• Code: 200.20
• Description: The media is too long over the manual feeder sensor. Possible causes include multi-sheet feed, media size (length) problem, pre-staged media in the tray.
• Remedy: Verify that the media is approved. Inspect the wear strips in the tray, and replace if they are worn.