Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi OKI C9650 — Trang 5/11

Code: 124

Display: Service Call 124: Error
Description: Sensor detects an inappropriate room temperature for the operating environment.
Remedy: 1) Is an Error message displayed? 2) Does the Error take place again?
Turn ON power again. Replace the environmental sensor.

Code: 125

Display: Service Call 125: Error
Description: Error detected in MPT home position.
Remedy: 1) Is an Error message displayed? 2) Does the Error take place again?
Turn ON power again. Replace MPT

Code: 126

Display: Turn OFF the power and wait for awhile. 126: Dew Error
Description: Sensor Dew Error
Remedy: Sensor Dew Error Detected Wait a while then turn ON power again.

Code: 128

Display: Service Call 128: Error
Description: Engine FAN Motor Error
Error was detected in each fan.
01: Fuser FAN Error 02: Power FAN Error 03: PU Motor FAN Error 04: Belt FAN Error 05: IDFAN Error 06: Top Cover FAN Error
Remedy: Is the applicable location of the fan connection normal? If the condition does not change Replace fan.

Code: 131 ... 134

Display: Service Call 131: Y Head 132: M Head 133: C Head 134: K Head
Description: After turning ON the power or when cover is closed, the sensor detects that the unit is missing.
Remedy: 1) Is an Error message displayed? 2) Is the LED head properly mounted? 3) Does the Error take place again?
ICheck the OED head unit. Turn ON power again. Replace the LED head Assy.

Code: 140 ... 142

Display: Service Call 140: Y 141: M 142: Error
Description: Color ID up/down error is detected.
Remedy: 1) Is an Error message displayed? 2) Does the Error take place again?
Turn ON power again. Confirm that the Y, M, and C ID units are in position, and reboot.

Code: 144 ... 147

Display: Service Call 144: Y ID 145: M ID 146: C ID 147: K ID
Description: This is indicated when the toner feed switch error or the toner locklever- open error occurs repeatedly when new toner is used.
Remedy: 1) Is the toner lock-lever-open error indicated? 2) Does the problem persist even if the ID units are replaced?
Confirm that the lever is in position. Replace the toner feed unit. Replace the ID units.

Code: 150 ... 153

Display: Service Call 150: Y 151: M 152: C 153: K
Description: When ID unit fuse cannot be cut.
Check if the ID Unit is normally mounted.
Remedy: Check if the ID Unit is normally mounted. Yes Check cable connection, then replace engine PCB.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie