Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi OKI C9650 — Trang 6/11

Code: 154

Display: Service Call 154: Error
Description: When belt unit fuse cannot be cut.
Remedy: Is the belt unit mounted normally? Yes Check cable connection, then replace engine PCB.

Code: 155

Display: Service Call 155: Error
Description: When fuser unit fuse cannot be cut.
Remedy: Is the fuser unit mounted normally? Yes Check cable connection, then replace engine PCB.

Code: 160 ... 163

Display: Service Call 160: Y Toner 161: M Toner 162: C Toner 163: K Toner
Description: Toner sensor detected error.
Remedy: 1) Is an Error message displayed? 2) Does the Error take place again?
Replace toner sensor or Assy (SGG-PWB). Replace toner sensor or Assy (SGG-PWB).

Code: 167

Display: Service Call 167: Error
Description: Thermistor Slope Error
Remedy: 1) Is an Error message displayed? 2) Does the Error take place again?
Turn ON power again. Leave in that state for 30 minutes then turn ON power again.

Code: 168

Display: Service Call 168: Error
Description: Compensation Thermistor Error
Remedy: 1) Is an Error message displayed? 2) Does the Error take place again?
Turn ON power again. Leave in that state for 30 minutes then turn ON power again.

Code: 169

Display: Service Call 169: Error
Description: Upper Side Thermistor Error
Remedy: 1) Is an Error message displayed? 2) Does the Error take place again?
Turn ON power again. Leave in that state for 30 minutes then turn ON power again.

Code: 170 ... 175

Display: Service Call 170: Error 171: Error 174: Error 175: Error
Description: Fuser Thermistor short-circuit or Open is detected (High Temperature (HOT) or Low Temperature (COLD))
Remedy: 1) Is an Error message displayed? 2) Does the Error take place again?
Turn ON power again. Leave in that state for 30 minutes then turn ON power again.

Code: 172 ... 176

Display: Service Call 172: Error 176: Error
Description: Thermistor indicates High Temperature (HOT) Error.
Remedy: 1) Is an Error message displayed? 2) Does the Error take place again?
Turn ON power again. Leave in that state for 30 minutes then turn ON power again.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie