Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio 1232C — Trang 6/17

Code: 541

Description: Thermistor disconnection (heating roller)
The fusing unit starts warm up to the print ready temperature. → The temperature does not reach 7°C for 10 seconds.
Causes: • Defective thermistor • Thermistor loose connection • Defective connector

Code: 542

Description: Fusing warm-up timeout (heating roller)
The main switch is turned on or a cover is closed. → The heating roller does not reach the warm-up temperature within 50 seconds.
Causes: • Defective lamp (loose connection, thermostat failure, PSU, thermostat) • Incorrect detection (loose thermistor connection, fusing - drawer loose connection)

Code: 543

Description: Overheat error (heating roller)
The heating roller thermistor detects 220°C for 5 seconds.
Causes: • Short circuit • Defective BICU board • Defective PSU

Code: 544

Description: Low temperature error (heating roller)
During standby or operation, the heating roller thermistor detects 100 °C or less for 5 seconds.
Causes: • Defective lamp (loose connection, thermostat failure, PSU, thermostat) • Incorrect detection (loose thermistor connection, fusing - drawer loose connection)

Code: 545

Description: Full power error (heating roller)
Fusing unit warm-up is complete. → The heating roller stops turning. → The heating roller lamp keeps outputting the maximum power for 30 seconds.
Causes: • Thermistor loose connection • Fusing - drawer loose connection

Code: 546

Description: Unstable temperature (heating roller)
The heating roller thermistor detects unstable temperature increases or decreases within 60 seconds.
Causes: • Thermistor loose connection • Fusing - drawer loose connection

Code: 551

Description: Thermistor disconnection (pressure roller)
The pressure roller thermistor detects 7°C or lower for 30 seconds.
Causes: • Thermistor loose connection • Defective harness • Defective connector

Code: 552

Description: Warm-up time over (pressure roller)
The main switch is turned on or a cover is closed. → The fusing pressure roller does not reach the ready temperature within 200 seconds.
Causes: • Defective lamp (loose connection, thermostat failure, PSU, thermostat) • Incorrect detection (thermistor loose connection, fusing - drawer loose connection)
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie