Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio 2090 — Trang 20/21

Code: SC951

Description: F-GATE Signal Error
When the IPU has already received the F-GATE signal (laser writing start trigger signal), the IPU receives another F-GATE signal.
Causes: • Software defective; switch off/on, or change the BCU firmware if this does not solve the problem • BCU defective

Code: SC953

Description: Scanner Image Setting Error
The settings required for image processing using the scanner are not sent from the IPU.
Causes: • Check the connections between the MCU and LCDC and BCU • Replace the MCU, BCU, or IPU • Change the BCU or MCU firmware

Code: SC954

Description: Printer Image Setting Error
The settings that are required for image processing using the printer controller are not sent from the IPU.
Causes: • Check the connections between the IPU and the LDB, and from the LDB to the polygon mirror motor control PCB. • Change the IPU or LDB • Change the polygon mirror motor or the polygon mirror motor control PCB • Change the BCU firmware

Code: SC955

Description: Memory Setting Error
The settings that are required for image processing using the memory are not sent from the IPU.
Causes: • Format the hard disks • Change the hard disks • Controller defective • Change the mother board or IPU • Change the controller firmware or the BCU firmware

Code: SC964

Description: Scanner Start Error
During scanned image processing, another command to start scanning was received.
Causes: • Change the BCU firmware

Code: SC965

Description: Print Start Error
During print processing, another command to start printing was received.
Causes: • Change the BCU firmware

Code: SC966

Description: Polygon Mirror Motor Ready Error
The polygon mirror motor does not reach ready status within 15 s after the copy paper is detected by the registration sensor. (15 s after the write request was issued for the IPU, the F-GATE signal remained LOW.)
Causes: • Polygon mirror motor defective • Poor connection between polygon mirror motor drive board and BCU • Polygon mirror motor drive board defective • BCU defective

Code: SC970

Description: Scanner Ready Error
The scan ready signal is not generated by the MCU for more than 10 s after the read start signal is sent to the MCU.
Causes: • Serial data transfer between MCU and BCU (through the LCDC) • Change the MCU firmware
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie