Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio 2090 — Trang 12/21

Code: SC703

Description: ADF Transport Belt Motor Error
While the motor is operating, the encoder pulse signal is not received within the specified time and the transport belt motor does not turn properly.
Causes: • Transport belt motor defective • Poor connection between the transport motor and ADF main board • ADF main board defective

Code: SC704

Description: ADF Feed-out Motor Error
While the feed-out motor is operating, the encoder pulse signal is not receivedwithin the specified time, and the feed-out motor does not turn properly
Causes: • Feed-out motor defective • Poor connection between the feed-out motor and ADF main board • ADF main control board defective

Code: SC705

Description: ADF Original Table Lift Malfunction
One of the following conditions was detected. • The bottom plate position sensor does not activate when the bottom plate motor lifts the original table. • The bottom plate HP sensor does not activate when the bottom plate motor lowers the original table.
Causes: • Bottom plate position sensor defective • Bottom plate HP sensor defective • Bottom plate motor defective • ADF main control board defective

Code: SC720

Description: Finisher Lower Transport Motor Error
The encoder pulse signal of the lower transport motor (B478) or stapler transport motor (B468) does not change within the specified time, and the lower transport motor does not turn properly
Causes: • Lower transport motor/stapler transport motor defective • Poor connection between the lower transport motor (or stapler transport motor) and finisher main board • Finisher main control board defective • Motor overload

Code: SC722

Description: Finisher Jogger Motor Error
The jogger fences move out of the home position but the HP sensor output does not change within the specified number of pulses.
Causes: • Jogger HP sensor (B478)/ jogger fence HP sensor (B468) defective • Overload on the jogger mechanism • Jogger motor (B478)/jogger fence motor (B468) defective (not rotating) • Finisher main control board defective • Poor connection between the jogger motor and finisher main board

Code: SC724

Description: Finisher Staple Hammer Motor Error
Stapling does not finish within the specified time (450 ms) after the staple hammer motor turned on.
Causes: • Staple jam • Overload because number of sheets exceeds the limit • Staple hammer motor (B478)/stapler motor (B468) defective • Poor motor cable connection

Code: SC725

Description: Finisher Stack Feed-out Motor Error
The stack feed-out belt HP sensor does not activate within the specified time after the stack feed-out belt motor turned on.
Causes: • Stack feed-out HP sensor defective • Poor stack feed-out belt motor cable connection • Stack feed-out belt motor defective • Finisher main control board • Motor overload

Code: SC726

Description: Finisher Shift Motor Error (B478 only)
The shift tray half-turn sensor status does not change within 1 second after the shift motor turns on.
Causes: • Shift tray half-turn sensor defective • Poor shift tray half-turn sensor connection or defective harness • Shift motor defective • Finisher main control board defective • Motor overload
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie