Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio 240W — Trang 3/6

Code: 522

Description: Fusing Unit Drive Motor
Error The lock signal goes LOW after the motor starts and gets to the set speed. If the fusing motor lock signal stayed HIGH for 5 seconds during motor operation, the motor stopped because of overloading.
Causes: • Check that the motor drive path is not overloaded. • Replace the motor.

Code: 530

Description: Fusing Unit Ventilation Fan Error
The lock signal goes LOW after the motor starts and gets to the set speed. If the fan motor lock signal stayed HIGH for 5 seconds during motor operation, the motor stopped because of overloading.
Causes: • Check that the motor is not overloaded. • Replace the motor.

Code: 541-1

Description: Fusing Thermistor Error 1
• The measured temperature of the hot roller stayed below 7C (44.6F) for 60 seconds after the machine was switched on. -or- • During machine operation the hot roller temperature fell to and stayed at 7C (44.6F) for 40 seconds.
Causes: • Make sure that the thermistor is set correctly. • Make sure that the thermistor cable is connected. • Replace the thermistor.

Code: 541-2

Description: Fusing Thermistor Error 2
The analog voltage input from the hot roller temperature was less than 2 V for three measurements. The thermistor has short-circuited.
Causes: • Replace the thermistor.

Code: 542

Description: Fusing Temperature Warm-up Error
The hot roller did not get to the ready temperature within 4 minutes 30 sec.: • After the machine was switched on. • After the upper unit or roll feeder drawer was closed. • During warm-up.
Causes: • Check the fusing lamp connections. • Replace the fusing lamp. • Replace the MCU. • Check the hot roller thermistor. Make sure that it is straight and does not touch the hot roller.

Code: 543

Description: Fusing Lamp Overheated: Error 1 (Software)
A fusing temperature more than 230 °C (446°F) was detected 3 times (measured at 180 ms intervals). Note: A shorted triac or other problem could cause the fusing lamp to stay on.
Causes: • Replace the MCU.

Code: 544

Description: Fusing Lamp Overheated: Error 2 (Hardware)
A short circuit in the triac on the MCU caused the fusing temperature control to stop or operate incorrectly. A special circuit on the MCU monitors the temperature of the board. The temperature around the board was more than 235C. 544-1 Latch Signal On (50 ms) 544-2 Signal On (1 s)
Causes: • Replace the MCU.

Code: 545

Description: Fusing Lamp Overheated: Error 3
After it got to the ready temperature, the fusing lamp stayed on at full power for 50 seconds while the hot roller did not turn.
Causes: Correct the position of the thermistor on the hot roller. Replace the fusing lamp harness. Replace the MCU.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie