Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio 240W — Trang 2/6

Code: 400

Description: ID Sensor Auto Adjustment Error
Vsg did not get to 4±0.2 V when the ID sensor was adjusted automatically in the SP mode.
Causes: • Clean the ID sensor. • Check the ID sensor harness and connector. • Replace the ID sensor. • Replace the MCU. • Replace the development unit. • Replace the CGB power pack.

Code: 401

Description: ID Sensor Vsg Error
The Vsg level was detected lower than 2.5 V two times.
Causes: • Clean the ID sensor. • Check the ID sensor harness and connector. • Replace the ID sensor. • Replace the MCU. • Replace the development unit. • Replace the CGB power pack.

Code: 402

Description: ID Sensor Vsp Error
The Vsp level was detected at 0 V or more than 2.5 V for 2 consecutive copies.
Causes: • Under the left upper cover, make sure that the hex screw of the main drive gear of the drum is tight. • Clean the ID sensor. • Check the ID sensor harness and connector. • Replace the ID sensor. • Replace the MCU. • Replace the development unit. • Replace the CGB power pack.

Code: 440

Description: Transfer Output Error
A high voltage feedback voltage of less than 1.0 V was detected for 200 ms.
Causes: • Check and replace the high voltage cable if necessary. • Replace the CGB power pack.

Code: 460-1

Description: DC Separation Corona Output Error
A dc separation feedback voltage of less than 1.0 V was detected after more than 200 ms while the PWM duty value was more than 15%.
Causes: • Check and replace the high voltage cable if necessary. • Replace the CGB power pack.

Code: 508

Description: Cutter Error
The left and right cutter HP sensors stayed on or off more than 2 seconds.
Causes: • Check the connections of the HP sensors on the left and right side. • Replace the HP sensors.

Code: 520

Description: Main Motor Error
The lock signal goes LOW after the motor starts and gets to the set speed. If the main motor lock signal stayed HIGH for 5 seconds during motor operation, the motor stopped because of overloading.
Causes: • Check that the motor drive path is not overloaded. • Replace the motor harness. • Replace the motor.

Code: 521

Description: Drum Motor Error
The lock signal goes LOW after the motor starts and gets to the set speed. If the drum motor lock signal stayed HIGH for 5 seconds during motor operation, the motor stopped because of overloading.
Causes: • Check that the motor drive path is not overloaded. • Replace the motor.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie