Code :

Code: SC776
Description: Jogger Bottom Fence Motor: 3K Finisher B830
The bottom fence HP sensor detected that: The bottom fence did not arrive at the home position at the specified time. -or- The bottom fence failed to leave the home position at the specified time.
Causes: • If the jogger bottom fence motor is operating: 1 Bottom fence HP sensor harness loose, broken, defective 2 Bottom fence HP sensor defective
• If the jogger bottom fence motor is not operating: 1 Motor blocked by an obstruction 2 Motor harness loose, broken, defective 3 Motor defective 4 Finisher main board defective

Code: SC780
Description: Z-Fold Feed Motor Error
The feed motor that drives the feed rollers and exit rollers in the Z-fold unit is not operating. The 1st alert signals a jam, the 2nd alert triggers this SC.
Causes: • Motor harness loose, broken, defective
• Motor blocked by an obstruction
• Motor defective

Code: SC781
Description: Z-Fold Lower Stopper Motor Error
The lower stopper failed to leave the home position with the specified number of motor pulses.
Note: The 1st detection failure issues a jam error, and the 2nd failure issues this SC code.
Causes: • Lower stopper motor disconnected, defective
• Lower stopper motor overloaded due to obstruction
• Lower stopper HP sensor disconnected, defective

Code: SC782
Description: Z-fold Upper Stopper Motor
The upper stopper failed to leave the home position with the specified number of motor pulses.
Note: The 1st detection failure issues a jam error, and the 2nd failure issues this SC code.
Causes: • Upper stopper motor disconnected, defective
• Upper stopper motor overloaded due to obstruction
• Upper stopper HP sensor disconnected, defective

Code: SC784
Description: Z-Fold Timing Sensor Adjustment Error 1
The output voltage light emitted from the sensor changed, but the return input was not sufficient to attain V0
Causes: • Sensor, mirror dirty from paper dust, other particles
• Harness loose, broken, defective
• Mirror out of position

Code: SC785
Description: Z-Fold Timing Sensor Adjustment Error 2
The output voltage light emitted from the sensor changed, but the return input was not sufficient to attain V0.
Causes: • Sensor, mirror dirty from paper dust, other particles
• Harness loose, broken, defective
• Mirror out of position

Code: SC786
Description: Z-Fold Memory Error
Several attempts to write to the Z-fold memory failed.
Causes: • Cycle the machine off/on
• EEPROM defective

Code: SC790
Description: Booklet Stapler Jogger Motor Error
The jogger fence HP sensor failed to detect the jogger fence at the home position within the specified time.
Causes: • If the booklet stapler jogger motor is operating: 1 Jogger fence HP sensor harness loose, broken, defective 2 Jogger fence HP sensor defective
• If the jogger bottom fence motor is not operating: 1 Motor blocked by an obstruction 2 Motor harness loose, broken, defective 3 Motor defective 4 Finisher main board defective