• Code: 542-001
• Description: Fusing reload failed: Fusing temperature warm-up error
  • The fusing temperature doesn’t rise by more than 7 degrees for two seconds; and this happens 5 times consecutively.
  The measure is start in 3.5 seconds after activation of the heater. This monitoring will stop in the case of reaching the reload temperature.
• Causes: • Defective thermistor
  • Power source is out of warranty

• Code: 542-003
• Description: Fusing reload failed: Time out error
  (On the fusing roller inactive) NOT reaching the reload temperature in 25 seconds after starting heater control.
• Causes: • Disconnection of Heater After activation of the anti-overheat device

• Code: 543
• Description: Fusing overheat error 1
  The fusing temperature detected by the thermistor is 230°C or higher for one second.
• Causes: • Defective the triac (Semiconductor device) • Defective the IOB control board
  • Detective the BICU control board

• Code: 544
• Description: Fusing overheat error 2
  The fusing temperature detected by the monitor circuit is 250°C or higher.
• Causes: • Defective the triac (Semiconductor device)
  • Defective the IOB control board
  • Defective the BICU control board
  • Uncontrollable fusing condition

• Code: 545
• Description: Fusing lamp overheat error
  The fusing lamp remains on for 12 seconds after starting the waiting mode.
• Causes: • Defective thermistor
  • Disconnection of Heater
  • After activation of the anti-overheat device

• Code: 547-001
• Description: Zero cross signal malfunction
  Detecting fusing contact meltdown
• Causes: • Defective the fusing relay (Contact adhesion, Contact separation)
  • Defective the drive circuit in the fusing relay
  • PSU fuse (24VS) meltdown
  • Unsteadiness in frequency of the commercial power source

• Code: 547-002
• Description: Zero cross signal malfunction
  Detecting wrong with fusing contact
• Causes: • Defective the fusing relay (Contact adhesion, Contact separation)
  • Defective the drive circuit in the fusing relay
  • PSU fuse (24VS) meltdown
  • Unsteadiness in frequency of the commercial power source

• Code: 547-003
• Description: Zero cross signal malfunction
  Detecting low-frequency wave
• Causes: • Defective the fusing relay (Contact adhesion, Contact separation)
  • Defective the drive circuit in the fusing relay
  • PSU fuse (24VS) meltdown
  • Unsteadiness in frequency of the commercial power source