Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio MP7001 — Trang 25/28

Code: 872

Description: HDD mail RX data error
An HDD error was detected immediately after power on. The HDD may be defective or the machine was accidentally powered off while the HDD was being accessed.
Causes: • Reformat the HDD with SP5832-7 (Mail RX Data) • Replace the HDD
Remedy:

Code: 873

Description: HDD mail send data error
An error was detected on the HDD immediately after the machine was turned on, or power was turned of while the machine used the HDD.
Causes: • Do SP5832-007 (Format HDD – Mail TX Data) to initialize the HDD. • Replace the HDD.
Remedy:

Code: 874

Description: Delete All Error 1: HDD
A data error was detected for the HDD/NVRAM after the "Delete All" option was used. Note: The source of this error is the Data Overwrite Security Unit running from an SD card.
Causes: • Turn the main switch off/on and try the operation again. • Install the Data Overwrite Security Unit again. For more, see section "MFP Options" in "Installation". • HDD defective.
Remedy:

Code: 875

Description: Delete All Error 2: Data area
An error occurred while the machine deleted data from the HDD Note: The source of this error is the Data Overwrite Security Unit running from an SD card.
Causes: • Turn the main switch off/on and try the operation again.
Remedy:

Code: 876

Description: Log data abnormal
An error was detected in the handling of the log data at power on or during machine operation. This can be caused by switching the machine off while it is operating.
Causes: • Software error. Update the firmware • NVRAM defective • HDD defective
Remedy:

Code: 877

Description: Data Overwrite Security SD card error
An error occurred, preventing successful execution of the Data Overwrite Security function, even though it has been set up and enabled.
Causes: • DOS card is not inserted completely into the SD card slot • DOS card has been removed from the SD card slot. • DOS card is damaged. Note: • If the SD card has been removed (or was not installed correctly), switch the machine off, insert the SD card, then switch on the machine again. • If the SD card has been damaged, procure a new SD card, replace the NVRAM, then do the DOS option installation.
Remedy:

Code: 878

Description: TPM electronic authentication error
The system hash value registered in TPM and the value registered in USB flash memory are not same during system booting.
Causes: • The system module was updated through the prescribed update root, so the controller board became defective. • USB flash memory did not work correctly.
Remedy:

Code: 880

Description: Media Link Board Error
A request for access to the Media Link Board was not answered within the specified time.
Causes: • Media Link Board defective.
Remedy:
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie