• Code: 722-10
• Description: Transport motor error (D610) A pulse signal from the transport motor could not be detected within the prescribed time. The first detection triggers a jam code, and the second detection triggers this SC.
• Causes: • Motor overload due to an obstruction • Motor harness connector loose, broken, defective • Motor defective

• Code: 722-24
• Description: Exit guide motor (D610) The status of the exit guide sensor did not change at the prescribed time during operation of the exit guide.
• Causes: • Exit guide open sensor loose, broken, defective. • Exit guide motor defective • Finisher main board defective

• Code: 722-25
• Description: Punch motor error (D610) After the punch operation, the punch HP sensor did not detect the punch unit at the home position.
• Causes: • Punch motor connection loose, broken, defective. • Punch overload (blocked by obstruction) • Home position sensor connection loose, broken, defective • HP sensor defective

• Code: 722-30
• Description: Finisher jogger motor error (D610) • The finisher jogger HP sensor remains de-activated for more 1,000 pulses when returning to home position. • The finisher jogger HP sensor remains activated for more than 1,000 pulses when moving away from home position.
• Causes: • Jogger HP sensor defective • Jogger mechanism overload • Jogger motor defective (not rotating) • Finisher main board defective • Harness disconnected or defective

• Code: 722-33
• Description: Finisher staple hammer motor error (D610) The staple hammer motor did not return to the home position within the prescribed time (340 ms).
• Causes: • Staple hammer HP sensor loose, broken, defective • Electrical overload on the stapler drive PCB elect • Staple hammer motor defective • Finisher main board defective

• Code: 722-35
• Description: Stack Plate Motor Error 1: Front Motor(D610) The stack plate HP sensor (front) does not activate within 500 ms after the motor turns on. The 1st detection failure causes a jam error, and the 2nd failure causes this SC code.
• Causes: If the motor is operating • Front stack plate HP sensor harness loose, broken, defective • Front stack plate HP sensor defective If the motor is not operating: • Motor blocked by an obstruction • Motor harness loose, broken, defective • Motor defective • Booklet finisher main board defective

• Code: 722-36
• Description: Stack Plate Motor Error 2: Center Motor (D610) The stack plate HP sensor (center) does not activate within 500 ms after the motor turns on. The 1st detection failure causes a jam error, and the 2nd failure causes this SC code.
• Causes: If the motor is operating • Center stack plate HP sensor harness loose, broken, defective • Center stack plate HP sensor defective If the motor is not operating: • Motor blocked by an obstruction • Motor harness loose, broken, defective • Motor defective • Booklet finisher main board defective

• Code: 722-37
• Description: Stack Plate Motor Error 3: Rear Motor (D610) The stack plate HP sensor (rear) does not activate within 500 ms after the motor turns on. The 1st detection failure causes a jam error, and the 2nd failure causes this SC code.
• Causes: If the motor is operating • Rear stack plate HP sensor harness loose, broken, defective • Rear stack plate HP sensor defective If the motor is not operating: • Motor blocked by an obstruction • Motor harness loose, broken, defective • Motor defective • Booklet finisher main board defective