Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio MPC2010 — Trang 16/18

Code: 827

Description: Self-diagnostic error: Standard SDRAM DIMM [XXXX]: Detailed error code
Causes: [0201] Verification error Error detected during a write/verify check for the standard RAM (SDRAM DIMM). • Loose connection • Defective SDRAM DIMM • Defective controller 1. Turn the main switch off and on. 2. Replace the SDRAM DIMM. 3. Replace the controller. [0202] Resident memory error The SPD values in all RAM DIMM are incorrect or unreadable. • Defective RAM DIMM • Defective SPD ROM on RAM DIMM • Defective 12C bus 1. Replace the RAM DIMM.
Remedy:

Code: 828

Description: Self-diagnostic error: ROM [XXXX]: Detailed error code
Causes: [0101] Check sum error 1 • The boot monitor and OS program stored in the ROM DIMM is checked. If the check sum of the program is incorrect, this SC code is displayed.
Remedy:

Code: 829

Description: Self-diagnosis error: optional RAM [XXXX]: Detailed error code
Causes: [0401] Verification error (Slot 1) The data stored in the optional RAM in Slot 1 does not match the data when reading. • Not specified RAM DIMM installed • Defective RAM DIMM 1. Replace the RAM DIMM. 2. Replace the controller board.
Remedy:

Code: 833

Description: Self-diagnostic error 8: Engine I/F ASIC
Causes: [0F30] [0F31] • ASIC (Mandolin) for system control could not be detected. After the PCI configuration, the device ID for the ASIC could not be checked. Replace the VBCU [0F41] • ASIC (Mandolin) for system control could not be detected. After the PCI configuration, the device ID for the ASIC could not be checked. Replace the VBCU [50B1] Could not initialize or read the bus connection. • Check for loose connections at the mother board. Replace the mother board [50B2] Value of the SSCG register is incorrect. • Check for loose connections at the mother board. Replace the mother board
Remedy:

Code: 839

Description: USB NAND Flash ROM error
Causes: [9101] The ID of the USB NAND Flash ROM cannot be read. • Defective i-controller board Replace the i-controller board. [9110] The USB NAND Flash ROM is disconnected. • Defective i-controller board Replace the i-controller board.
Remedy:

Code: 851

Description: IEEE1394 interface error
The 1394 interface is unusable.
Causes: • Defective IEEE1394 • Defective controller.
Remedy: 1. Turn the main switch off and on. 2. Replace the IEEE1394 interface board. 3. Replace the controller.

Code: 857

Description: USB interface error The USB interface cannot be used due to a driver error.
Causes: • Defective USB driver • Loose connection
Remedy: 1. Check the connection. 2. Replace the USB board.

Code: 866

Description: SD card authentication error
A correct license is not found in the SD card.
Causes: • SD-card data is corrupted.
Remedy: Store correct data in the SD card.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie