Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio MPC2010 — Trang 12/18

Code: 565

Description: Pressure roller fusing lamp consecutive full power 3
When the fusing unit is not running in the ready condition, the pressure roller fusing lamp keeps ON full power for 250 seconds or more.amp on.
Causes: • Broken pressure roller thermostat • Broken pressure roller fusing lamp
Remedy: 1. Replace the pressure roller fusing lamp. 2. Replace the pressure roller thermostat. 3. Replace the PSU.

Code: 571

Description: Pressure roller thermister error 4
The temperature measured by the pressure roller thermistor (end) does not reach 0 °C for 20 seconds.amp on.
Causes: • Loose connection of pressure roller thermistor (end) • Defective pressure roller thermistor (end)r more.
Remedy: 1. Check that the pressure roller thermistor (end) is firmly connected. 2. Replace the pressure roller thermistor (end).

Code: 573

Description: Pressure roller overheat 4 (software error)
The detected pressure roller temperature stays at 230°C or more for 1 second.
Causes: • Defective pressure roller thermistor (end) • Defective PSU • Defective BCU
Remedy: 1. Replace the pressure roller thermistor (end). 2. Replace the PSU. 3. Replace the BCU.

Code: 574

Description: Pressure roller overheat 4 (hardware error)
The pressure roller thermistor (end) detects 250°C or more.
Causes: • Defective pressure roller thermistor (end) • Defective PSU • Defective BCU • Defective fusing control systemtem
Remedy: 1. Replace the pressure roller thermistor (end). 2. Replace the PSU. 3. Replace the BCU.

Code: 610

Description: Mechanical counter error: K
This SC is only for NA models. The machine detects the mechanical counter error when SP5987-001 is set to "1".
Causes: • Disconnected mechanical counter • Defective mechanical counter
Remedy: 1. Check or replace the mechanical counter. 2. Replace the BCU.

Code: 611

Description: Mechanical counter error: FC
This SC is only for NA models. The machine detects the mechanical counter error when SP5987-001 is set to "1".
Causes: • Disconnected mechanical counter • Defective mechanical counter
Remedy: 1. Check or replace the mechanical counter. 2. Replace the BCU.

Code: 620

Description: ARDF communication error
After the ARDF is detected, the break signal occurs or communication timeout occurs.
Causes: • Incorrect installation of ARDF • ARDF defective • BICU board defective • External noise
Remedy: 1. Check the cable connection of the ARDF. 2. Shut out the external noise. 3. Replace the ARDF. 4. Replace the BCU board.

Code: 632

Description: Counter device error 1
After 3 attempts to send a data frame to the optional counter device via the serial communication line, no ACK signal was received within 100 ms.
Causes: • Serial line between the optional counter device, the relay board and copier control board is disconnected or damaged • Make sure that SP5113 is set to enable the optional counter device.
Remedy:
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie