Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio MPC5002 — Trang 21/28

Code: 724-85

Description: Upper limit switch error (D585)
The upper limit switch of the 500-sheet finisher (D585) is pushed due to tray lift error or some problems.
Causes: • Upper limit switch pulled up • Defective upper limit swtich
Remedy: 1. Check the harness. 2. Check for blockage around the upper limit switch. 3. Replace the upper limit switch.

Code: 770

Description: Shift motor error
The shift motor HP sensor does not detect any change for 1.86 seconds after the shift motor has turned on at power on or during its operation.
Causes: • Defective shift motor • Defective shift motor HP sensor
Remedy: 1. Check the connections to the shift motor and the shift motor HP sensor. 2. Replace the shift motor or the shift motor HP sensor.

Code: 791

Description: Bridge unit error
The machine recognizes the finisher, but does not recognize the bridge unit.
Causes: • Defective connector • Broken harness
Remedy: 1. Check the connections between the bridge unit and the machine. 2. Install a new bridge unit.

Code: 792

Description: Finisher error
The machine does not recognize the finisher, but recognizes the bridge unit.
Causes: • Defective connector • Defective harness • Incorrect installation
Remedy: 1. Check the connections between the finisher and the machine. 2. Install a new finisher.

Code: 816

Description: Energy saving I/O sub-system error
The energy saving I/O sub-system detects an error.
Causes: • Controller board defective
Remedy: Replace the controller board.

Code: 817

Description: Monitor error This is a file detection and electronic file signature check error when the boot loader attempts to read the self-diagnostic module, system kernel, or root system files from the OS Flash ROM, or the items on the SD card in the controller slot are false or corrupted.
Causes: • OS Flash ROM data defective • SD card data defective
Remedy: 1. Change the controller firmware. 2. Use another SD card.

Code: 819

Description: Fatal kernel erro
Due to a control error, a RAM overflow occurred during system processing. One of the following messages was displayed on the operation panel.
Causes: • System program defective • Controller board defective • Optional board defective
Remedy: 1. Replace the controller firmware.

Code: 821

Description: Self-diagnostics error: ASIC
Causes: [0B00] ASIC register check error The write-&-verify check has occurred in the ASIC. Defective ASIC device 1. Replace the controller board. [0B06] ASIC detection error The I/O ASIC for system control is not detected. • Defective ASIC • Defective North Bridge and PCII/F 1. Replace the controller board.
Remedy:
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie