• Code: SC516
• Description: Duplex jogger motor error 2
  When the jogger fence moves from the home position, the jogger fence HP sensor does not turn off even if the jogger motor has moved the jogger fence 153.5 mm.
• Causes: • Jogger fence motor defective or poor connection • Paper or other obstacle interfering with operation of the sensors or motor • Return sensor or HP sensor defective, dirty, or disconnected • Paper or other obstacle has jammed mechanism • HP sensor connector disconnected or defective • HP sensor defective

• Code: SC517
• Description: LCIT air assist front fan error
  The front air assist fan is not functioning properly.
• Causes: • Fan harness disconnected or damaged • Fan blocked by an obstruction • Fan damaged, defective

• Code: SC518
• Description: LCIT air assist rear fan error
  The rear air assist fan is not functioning properly.
• Causes: • Fan harness disconnected or damaged • Fan blocked by an obstruction • Fan damaged, defective

• Code: SC530
• Description: Fusing cooling fan error
  The VBCU did not receive the lock signal 5 seconds after the fusing unit fan switches on.
• Causes: • Fan harness disconnected or damaged • Fan blocked by an obstruction • Fan damaged

• Code: SC531
• Description: Fusing Fan Error: Front
  The lock signal remained HIGH for 5 sec. while the fan at the front of the fusing unit near the heat dissipation fins was operating.
• Causes: • Fan harness disconnected or damaged • Fan blocked by an obstruction • Fan damaged

• Code: SC532
• Description: Controller fan error
  The lock signal remained HIGH for 5 sec. while the fan that cools the printed circuit boards was operating.
• Causes: • Fan harness disconnected or damaged • Fan blocked by an obstruction • Fan damaged

• Code: SC533
• Description: Fusing unit suction fan error
  The lock signal remained HIGH for 5 sec. while the fan that draws air out of the fusing unit was operating.
• Causes: • Fan harness disconnected or damaged • Fan blocked by an obstruction • Fan damaged

• Code: SC533-1
• Description: Fusing exit fan error
  The machine detected a fan lock signal 5 times at 1 sec. intervals. This indicates that the fan is not operating and the machine stops.
• Causes: • Fan connection loose, broken, defective • Fan is blocked by an obstruction • Fan motor is defective