Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio MPC7501 — Trang 27/44

Code: SC562

Description: Heating roller non-contact thermistor error 2
After the main switch is turned on or the cover is closed, the heating roller temperature does not reach the ready temperature within 100 sec. after the heater switches on. -or- The heating roller did not reach the ready temperature within 150 sec.
Causes: • Do SP5810 to cancel the SC fusing code • Defective hot roller thermistor • Heating roller disconnected, defective

Code: SC563

Description: Heating roller non-contact thermistor error 3
The thermistor 2 (of the heating roller) detected a temperature over 250°C 10 times within 1 sec.
Causes: • Do SP5810 to cancel the SC fusing code. • TRIAC short, AC drive board defective • VBCU defective

Code: SC564

Description: Heating roller non-contact thermistor error 3
The thermistor detected a temperature over 260°C.
Causes: • Do SP5810 to cancel the SC fusing code. • TRIAC short, AC drive board defective • VBCU defective

Code: SC565

Description: Heating roller fusing lamp on error
After fusing belt reached warm-up temperature, the heating roller fusing lamp remained on for 20 sec. while the hot roller was not rotating.
Causes: • Do SP5810 to cancel the SC fusing code. • Thermistor damaged, or out of position • Fusing lamp disconnected, broken

Code: SC566

Description: Heating roller non-contact thermistor 3
Thermistor detected a temperature less than 0 degrees more than three times.
Causes: • Do SP5810 to cancel the error. • Hot roller thermistor connector disconnected, loose, broken, or defective.

Code: SC569

Description: Pressure roller lift error 2
Pressure roller lift motor not operating correctly. (No signal to indicate completion of operation.)
Causes: • Pressure roller lift sensor connection loose, broken, damaged • Clean the pressure roller lift sensor • Pressure roller lift harness loose, broken, damage • Pressure roller lift motor blocked by an obstruction • Pressure roller lift motor defective

Code: SC570

Description: Development intake fan error
Fan motor not operating correctly.
Causes: • Fan harness loose, broken, defective • Fan overload due to physical obstruction • Fan motor defective

Code: SC571

Description: Ozone exhaust fan (FC) error
The fan of the middle ozone filter box not operating correctly.
Causes: • Fan harness loose, broken, defective • Fan overload due to physical obstruction • Fan motor defective
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie